KUGOO S3 Electric Hoverboard and Scooter User Manual
- June 5, 2024
- KUGOO
Table of Contents
S3 Electric Hoverboard and Scooter
User Manual
Electric Scooter
Please red the user manual and get to know the performance of the intelligent electric scooter before using the product. Don’t lend the scooter to the people who can’t handle it.
Product diagram
1- Switch Button
2- Display
3- Power/Front Light
4- Right handlebar
5- Accelerator
6- Hook
7- Brake
8- Left handlebar
9- Front tube
10- Front Latch| 11- Charging port
12- Kickstand
13- Front fender
14- Front-wheel
15- Deck
16- Hook Hole
17- Rear fender
18- Rear Light
19- Rear wheel
---|---
Specification
Performance Index | Item | Specs |
---|
Materials & Size
| Color| Black/Red/White
Material| Aluminum Alloy
Folded Size (mm)| 970200480mm
Unfolded size (mm)| 9702001170mm
Deck Height (mm)| 75mm
Weight
| User height| 155-200cm
N.W| 9.5kg
Max Load| 100kg
Scooter
| Max speed (km/h)| 25km/h
Max incline| 7-15°
Using temperature| 0°C–45°C
Using Terrain| Flat road with incline <20°
Step height ≤1cm
Using temperature| 0°C–45°C
Waterproof level| IP54
Motor
| Rated power (W)| 250W
Rated Volt (V)| 24V
Rated Currency (A)| 13A
Rated torsion (N.m)| 5N.m
No-load currency| ≤0.9A
No-load rotate speed| 620±5
Front Wheel Size| 6 inch
Rear Wheel Size| 6 inch
Battery
| Brand| 18650 battery cells 2P7S 14PCS
Capacity (Ah)| 5.0Ah
Rated Volt (V)| 24V
Input Volt (V)| 29.4V
Intelligent BMS| Equilibrium/overcharge/over-discharge/Over current/short
circuit protection
Rechargeable times| 500-800times
Charger
| Rated Power (W)| 58.8W
Rated Volt (V)| 110-240V AC 50/60Hz 2A
Rated Currency (A)| 1.5A
Charging time| 3~ 4H
Rated output volt (V)| 29.4V
Front light| Working volt| 12V
Working currency| 100mA
Rear light| Working volt| 12V
Working currency| 30mA
Operation steps
Power button function description
-
Power on/off
Power on/off: Long press the red button on the right side to turn it on,
Long press again to turn it off. -
Gear switch
Gear switch: Short press the left red button , and the system can be switched among L-M-H three gears -
Lighting
Turn on/off: In the state of power-on, a short press on the right key can turn it on/off -
Setting status
Long press the key and the key at the same time to enter the “Settings” interface. In the setting state, the short press the key to switch between C1(unit)—C2(Startup mode)—C3(cruise control).
a) Unit settings
Switch to the C1 state in the “Settings” state: Short press the button to switch between KM/H and MP/H
b) Startup mode setting
Switch to the C2 state in the “Settings” state: Short press button to set the start mode of the scooter (Slide start/Zero start)
c) Cruise control setting
Switch to C3 state in “Settings” state: Short press key to set turn on/off cruise control
Safe Driving
- Avoid accentuating the body while accentuating or decelerating and do not keep the body weight on the handle
- Riding a standing position, please keep the two feet one after the other, so that riding is more stable and easy to step on the rear brake
- Keep your body and handle parallel when turning. Please confirm the road condition before turning and keep safe.
- Brake – when braking, please shift your body weight back. You’d better learn to control your body’s center of gravity when you brake. Otherwise, it will cause two situations:
1 Scooter forward, causing personal injury.
2 Braking and steering system damage.
Strictly abide by local laws and regulations and traffic laws
Do not rid this scooter under the condition of low visibility
Do not use this car to do stunts, wheel or take-off, it will increase the
probability of injury and damage to the scooter. Do not carry passengers.
There is a risk of falling down and injury during the course of study. Please
wear a helmet and protective gear throughout the study.
Charging precautions
When charging the electric scooter S3, please pay attention to the following points:
- Ensure that is changed in a dry and clean environment, the input voltage is guaranteed between 110v-240v and the other end connects to the charging port of S3 electric scooter. The red light indicates the scooter is being charged.
- The indicator light of the charger shows the green light, indicating that the charging is completed.
- Don’t turn on the scooter during charging for your safety.
- Disconnect the scooter from the charger when the charging is complete.
Maintenance
a. Battery maintenance: In order to guarantee the battery life, when the
battery level is low, please change the scooter timely (Note: when it is not
in use for a long time, it is recommended that charge it once a month). If you
want to check or replace the battery, please do it with the assistance of
professionals. The most suitable temperature of the battery storage is 15°C –
25°C; don’t use and place the scooter when the environmental temperature is
higher than 40°C, in order to avoid the lithium battery’s failure, and even
lead to the combustion. Do not place the scooter in the car during the hot
seasons, because it may lead to the lithium battery’s failure or even
combustion.
b. Tire maintenance: In order to guarantee the tire life, please check the
tires of the scooter regularly. Once the wheel is abnormal, please repair or
replace timely. Sp as mt to cause unnecessary damage during the riding.
c. Appearance maintenance: Swab the scooter body with water or mild detergent,
it will make your scooter clean. Please do not clean the scooter with
irritating points or chemical reagents.
Common Failures and Solutions
1)The display board is working but the motor doesn’t work
Reason Analysis
|
Solutions
The break handle is damaged| Pull out the socket of the brake handle (normally
open type brake handle), if the motor works, then it is the failure of the
brake handle, should replace the brake handle.
The speed regulating steering handle is damaged| Firstly check whether the
speed regulating steering handle and motor hall switch are short circuits or
not. Generally, it is easier to cause the joint to the short circuit after
rain-affected with dampness, so notice the short circuit of the steering
handle and the motor hall switch. Otherwise, there will be continuous damage
of the replacement controller!
The motor is damaged| If the motor doesn’t work turn, please inspect the
motor’s hall switch and turning handle’s signal. Once the power on, the
controller shall be very hot, generally it is a short circuit of the
controller’s internal power tube, which should immediately cut off the power.
2) Charging doesn’t work
Reason Analysis| Solutions
l The battery charging port is loose| Change a good charging port
l The connection of the charger plug is not well| Change a good charger
connector
3) Can’t turn on the scooter
Reason Analysis| Solutions
l The battery is dead| Charge the scooter for 1-2 hours according to the
user manual.
l The power button is out of order| Check whether the power button has got
stuck or not.
Thank you for your reading!
Electric Scooter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>