Anybus HMS IP Configurations User Manual
- June 3, 2024
- Anybus
Table of Contents
Anybus HMS IP Configurations
About HMS IPconfig
IPconfig is a Windows-based tool for configuration of TCP/IP settings in HMS
devices. IPconfig will detect all compatible and active HMS devices on the
local network.
The devices do not have to be on the same Ethernet subnet as the computer
running IPconfig.
Installation
- Download IPconfig from www.anybus.com/support.
- Unpack the contents of the zip archive and run the installer program.
Scanning for Connected Devices
When IPconfig is started it will automatically scan for compatible and active
HMS devices. To change the IP configuration for a device, click on the device
in the list.
- IPconfig device list
Web-interface Icons
Icon | Function | Description |
---|---|---|
Refresh | Refresh the device list | |
Options | Change the scan settings | |
Web | Open the device in the default web browser | |
Wink | Flash LED indicators on the device (if supported by the device) |
Device Configuration
- Ethernet configuration
The available configuration settings depend on the selected device. After editing the configuration, click on Apply to apply the new settings and reboot the device.
IP and DNS Configuration
IMPORTANT
If there is no DHCP server available on the network, do not enable DHCP.
IP and DNS settings can be configured manually or dynamically using DHCP.
Change Password
IMPORTANT
For security reasons the default password should always be changed.
To set a new password:
- Select the Change password checkbox.
- Enter the current password in the Password field.
- Enter the new password in the New password field.
Comment
This field can be used to add a name or description of the device for easier
identification. The comment is not uploaded to the device.
Version Information
Additional information about the device. This field cannot be edited.
Scan Settings
- IPconfig scan settings
IPconfig can be configured to scan for devices using only a specific network interface. The default setting is to scan using all network interfaces. The scan settings are saved when you exit IPconfig. If no devices are detected when you start up IPconfig, check this settings and change it to Scan using all Network Interface Controllers, then refresh the device list.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>