FAURE FFT919Y Decorative Hood User Manual
- June 5, 2024
- FAURE
Table of Contents
FAURE FFT919Y Decorative Hood User Manual
SAFETY INFORMATION AND INSTALLATION
WARNING!
Refer to the separate Installation Instructions booklet for Safety Information
and Installation.
Read carefully the Safety chapters before any use or maintenance of the
appliance.
PRODUCT DESCRIPTION
CONTROL PANEL OVERVIEW
- On / Off
- First motor speed
- Second motor speed
- Third motor speed
- Maximum motor speed
- Breeze function
- Filter reminder
- Hob to Hood function
- Lamp
DAILY USE
USING THE HOOD
Check the recommended speed according to the table below.
| While heating up food, cooking with covered pots.
---|---
| While cooking with covered pots on multiple cooking zones or burners, gentle
frying.
| While boiling and frying big quantities of food without a lid, cooking on
multiple cooking zones or burners.
| While boiling and frying big quantities of food without a lid, big humidity.
| Refreshes the air in kitchen after cooking at a very low noise level. It can
be activated and de-activated by touching the symbol. The function turns off
automatically after 60 minutes. Use after cooking only
It is recommended to leave the hood operating for approximately 15 minutes after cooking.
The control Panel is a sensor field.
Touch the symbols for 1 second to activate the functions.
To operate the hood:
-
Turn on the appliance by pressing the symbol.
You can now activate the functions. -
To activate the function touch the symbol.
-
If needed, touch the light symbol to illuminate the cooking surface.
To turn off the appliance press the symbol again.
HOB TO HOOD FUNCTION
It is an automatic function which connects the hob with a hood. Both the hob
and the hood have an infrared signal communicator. Speed of the fan is defined
automatically on basis of mode setting and temperature of the hottest cookware
on the hob.
You can also operate the fan using the hob manually. The function can be
activated from panel of the hob.
For more information how to use the function refer to the hob user manual.
ACTIVATING MAXIMUM MOTOR SPEED
When you press the button , the Maximum Motor Speed starts to operate for 8
minutes. After that time, the appliance returns to its previous
speed settings.
When the function is turned on, additional touch on the button does not have any effects.
ACTIVATING AND DEACTIVATING THE FILTER NOTIFICATION
Filter alarm reminds to change or clean the charcoal filter and clean the grease filter. The filter indicator is turned on (white) for 30 seconds if the grease filter must be cleaned. The filter indicator flashes (white) for 30 seconds if the charcoal filter must be replaced or cleaned.
Refer to filter alarm in care and cleaning chapter.
- Switch on the control panel.
- Make sure that the icons are turned off.
- To activate or deactivate the charcoal filter notification touch for 3 seconds.
If the charcoal filter notification is activated, the filter icon flashes (white) five times.
If the charcoal filter notification is deactivated, the filter icon flashes (white) three times.
CARE AND CLEANING
CLEANING THE GREASE FILTER
Each filter must be cleaned at least once a month. Filters are mounted with the use of clips and pins on the opposite side.
To clean the filter:
-
Press the handle of the mounting clip on the filter panel underneath the hood (1).
-
Slightly tilt the front of the filter downwards (2), then pull.
Repeat the first two steps for all filters. -
Clean the filters using a sponge with non abrasive detergents or in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the performance of the appliance. -
To mount the filters back follow the first two steps in reverse order.
Repeat the steps for all filters if applicable.
WARNING! The charcoal filter is nonwashable!
The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter.
To replace the filter:
-
Remove the grease filters from the appliance. Refer to “Cleaning the grease filter” in this chapter.
-
press the tab (1) and slightly tilt the front of the filter.
-
To install a new filter, perform the same steps in reverse order.
In any case, it is necessary to replace the filters at least every four months.
FILTER ALARM
Refer to activating and deactivating the filter alarm in daily use chapter.
Refer to cleaning the grease filter in this chapter.
Refer to cleaning the charcoal filter or replacing the charcoal filter (depends on filter type).
To reset the alarm:
Touch the for 3 seconds.
REPLACING THE LAMP
This appliance is supplied with a LED lamp and separate control gear (LED driver). These parts can be replaced by a technician only. In case of any malfunction refer to “Service” in the “Safety Instructions” chapter.
ENVIRONMENTAL CONCERNS
Recycle materials with the symbol . Put the packaging in relevant containers
to recycle it. Help protect the environment and human health by recycling
waste of electrical and electronic appliances. Do not dispose of appliances
marked with the symbol with the household waste.
Return the product to your local recycling facility or contact your municipal
office.
VISIT OUR WEBSITE TO
Get usage advice, brochures, trouble shooter, service and repair information: www.faure.com/support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>