IKEA TILLREDA Freestanding Fridge Instruction Manual

IKEA TILLREDA Freestanding Fridge

Warning! Before proceeding with installation, read the safety information in the User Manual. Don’t use extension cable or multiplug while you plug it to electricity circuit.

DIMENSION

INSTALLATION INSTRUCTION

1. Make sure that the appliance stands stable and level.
2. When installing in a certain usage scenario, please also refer to the user manual of the cabinet itself.

• Turn two front feet clockwise or anti-clockwise to adjust the height of the appliance for levelling. Tilt the appliance for 1/4″(6mm) from front to back to ensure door close and seal properly.

• If needed,the door can be reversed to open from the left side. Remove all items from the appliance before reversing the door.

• Remove two pin hole plugs on the top.

• Prepare to switch these plugs to the other side.

• Remove the upper hinge cover.

• Prepare to switch this hinge cover to the other side.

• Loosen two hinge screws.

• Remove the hinge.

• Prepare to switch this hinge to the other side.
  

• Please wear protective gloves before operation.

• Lift the door off the bottom hinge pin, then remove the door.

• Carefully place the door on the padded surface to avoid damage.

• Unscrew the door support and take it off, as shown in OR.

• Install the door support which was taken off from step 1 to the other side, as shown in

• Remove all items from the appliance.

• Carefully lay down the appliance on the padded surface to avoid damage.

• Loosen two hinge screws and remove the bottom hinge.

• Prepare to switch this hinge to the other side.

• Loosen one screw on the right side.

• Pre pa re to switch th is screw to the otherside.

• Turn the right front foot anti-clockwise until it is totally removed from appliance.

• Prepare to switch this foot to the other side.

• Fix the scew “B” and foot “C” to the left front side of the appliance.

• Fix the bottom hinge with two screws “D” to the right front side of the appliance.

• Carefully stand up the appliance.

• install all accessories and door.

• On the top right.attach the upper hinge “E” and shim “F” and fix with two screws.

• The screws can not be fixed too tight until step 14.

• Adjust the door until it is completely match with the cabinet.

• Tighten the screws.

• Attach the hinge cover “G” to upper hinge on the right.

• Attach two pin hole plugs “A” into hinge holes on the left. 

• Turn two front feet clockwise or anti-clockwise to adjust the height of the appliance for levelling.

• Tilt the appliance for 1/4″(6mm) from front to back to ensure door close and seal properly.

• Inter IKEA Systems B.V. 2022 AA-2245260-3

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>