WINPOWER D1 LED Headlight Installation Guide

WINPOWER D1 LED Headlight

Thank you for purchasing LED headlight bulbs. To ensure correct and safe use, please read this “Instruction Manual” carefully before use. In addition, please keep this instruction manual properly so as not to lose it while using this product.

This product 1s suitable for HID to LED conversion bulb D1 / D2 / D3 / D5 / D8

NOTE:

• Be sure to check the installation manual before use after ensuring safety.

• Valve ask a replacement professional is not to easy. inst.all If it. you are worried about installation, we recommend that

• Suitable for original genuine ballast, which can be installed directly.

• This direct product contact with adopts water, waterproof soil, dust, and etc.

• Dustproof design, but please do not make it come into
  but During hold the installation, connector do not and hold move the wire forward harness straight when If excessive installing or force is removing applied the to the connector, such terminal, as the it will melting generate of the heat due connector, to the and it terminal will not break be or removed poor due contact, to burning causing of the damage valve.

• Carry out lighting test before use.

Product Information

• WLEaDtt : H45eWad/3li5gWht s
• Color Tempe: 6500K e Set
• Color: Whit rature
• Content: LED bulb x 2

D5 Installation Instructions

1. Turn off the car engine, open
2. Remove the dust-proof the car hood, and let it coo
3. Remove the HID bulb. for 5 minutes. rear cover and unplug the power plug.
4. 4Connect the vehicle ballast to this product securely and check the lighting.
5. Secure with springs.
6. The dust-proof back cover can be restored to its original state, and the LED bulb can be installed.

D1/D3/D8 Installation Instructions

Turn oft the car engine, open the car hood, and let it cool for5 minutes. Remove the dust-proof back cover.

1. Rotate and take out the HID bulb and unplug the power plug.
2. Install the LED bulb base and fix it with a spring.
3. Connect the removed vehicle power supply to the valve wiring.
4. The dust-proof back cover can be restored to its original state, and the LED bulb can be installed.

D2S/D2R Installation Instructions

1. Unplug the power plug and rotate out the HID bulb.
2. Rotate and fix after inserting the lamp.
3. Connect the led driver to the power plug of the original car, taking care not to hinder the subsequent steering of the original car.
4. Put one the dust cover installation is complete.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>