WinPower D2 LED Headlight Bulb Instruction Manual
- June 4, 2024
- WinPower
Table of Contents
LED D1 / D2 / D3 / DS / D8 Headlight Installation Manual
Thank you for purchasing LED headlight bulbs. To ensure correct and safe use, please read this “Instruction Manual® carefully before use. In addition, please keep this instruction manual properly so as not to lose it while using this product.
This product is suitable for HID to LED conversion bulb D1 / D2 /D3/D5/D8
NOTE:
- Be sure to check the installation manual before use after ensuring safety.
- Valve replacement is not easy. If you are worried about installation, we recommend that you ask a professional to install it.
- Suitable for original genuine ballast, which can be installed directly.
- This product adopts waterproof and dustproof design, but please do not make it come into direct contact with water, soil, dust, etc.
- During installation, do not hold the wire harness when installing or removing the connector, but hold the connector and move forward straight. If excessive force is applied to the terminal, it will generate heat due to the terminal break or poor contact, causing damage such as the melting of the connector, and it will not be removed due to burning of the valve.
- Carry out lighting test before use.
Product Information
LED Headlights
Wart: 45W/35W
Color Temperature: 6500K
Color White
Set Content: LED bulb x 2
DS Installation Instructions
| |
---|---|---
1. (Turn off the car engine, open
the car hood, and let it cool for 5 minutes.| 2. Remove the dust-proof rear
cover and unplug the power plug.| 3. Remove the HID bulb.
| |
4. Connect the vehicle ballast to this product securely and check the
lighting.| 5. Secure with springs.| 6. The dust-proof back cover can be
restored to its original state, and the LED bulb can be installed.
D1/D3/D8 Installation Instructions
Turn off the car engine, open the car hood, and let it cool for 5 minutes.
Remove the dust-proof back cover.
|
---|---
Rotate and take out the HID bulb and unplug the power plug.| Install the LED
bulb base and fix it with a spring.
|
Connect the removed vehicle power supply to the valve wiring.| The dust-proof
back cover can be restored to its original state,
and the LED bulb can be installed.
D2S/D2R Installation Instructions
|
---|---
1. Unplug the power plug and rotate out the HID bulb.| 2. Rotate and fix
after inserting the lamp.
|
3. Connect the led driver to the power plug of the original car, taking care
not to hinder the subsequent steering of the original car.| 4. Put one the
dust cover installation is complete.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>