Lumens WS-RS-R6 Round Slim Panel Downlight 3 and 5 CCT Instruction Manual
- June 5, 2024
- Lumens
Table of Contents
Lumens WS-RS-R6 Round Slim Panel Downlight 3 and 5 CCT
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND RETAIN THEM FOR FUTURE REFERENCE.
Round Slim Panel Downlight-3&SCCT include LED Lamp, a Warning Label and
installation instructions. Please check these items when unpacking.
WARNING:
Failure to install and wire fixture or Install replacement Ballast In
accordance with the National Electrical Codes (NEC), all applicable Federal,
State and Local electrical codes, as well as specific U.L. safety standards
for the intended working environment (location/application), may cause serious
personal injury, or property damage.
IMPORTANT NOTE:
The safeguards and Instructions appearing in this page, are not meant to cover
all possible conditions and situations that may occur. It may be understood
that common sense, causes and care are factors which cannot be built into any
product. The person(s) installing, operation and responsible for the light
fixture, must execute these factors.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
Dimmer Compatibility:
LEVITON: ROO-RNL06-TW, RS0-IPL06-10M;
LUTRON: CT-600PR, MSCL-OP153MH, DVWCL-153PH, TGCL-153PR, MA-RR, DVCL-153PR,
SCL-153PR,
WARNING
- Risk of fire or electrical shock. Round Slim Panel Downlight-3&5CCT installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- Risk of fire or electrical shock. Do not alter, relocate or remove wiring, junction box, power supply or any other electrical components.
- Suitable for Wet Location.
- To prevent electrical shock, please wear rubber shoes and work gloves when installing the 6″ Round LED Ultra Slim Downlight.
- 5 Years Warranty is limited to the repair or replacement of defective lamps. Damages caused by abuse, misuse are not covered in Warranty.
THIS ROUND SLIM PANEL DOWNLIGHT-3&5CCT IS ACCEPTABLE AS A COMPONENT OF A LED LUMINAIRE WHERE THE SUITIBILITY BE DETERMINED BY CSA OR CANADIAN ATHORITIES HAVING JURISDICTION.
Installation Steps:
STEP l:
Turn off the power before installation. Remove the existing bulb and if necessary remove the existing trim. Open the hole on the mounting surface according to the size of fixture.
STEP 2:
Open the junction box, connect the power cable, as shown in Fig 2.
STEP 3:
Connect the fixture with power cable and the junction box, as shown in Fig3.
STEP 4:
Install the fixture to ceiling surface, as shown in Fig4.
STEP 5:
Turn on the power after installation, check the fixture can work well, as
shown in FigS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>