CryoFX High Pressure System Co2 Systems Instruction Manual
- June 5, 2024
- CryoFX
Table of Contents
CryoFX High Pressure System Co2 Systems
Operation Instructions
Once your CryoFX CO2 System is installed and/or hooked up and ready to use. please follow these simple steps to ensure a smooth operation and safe environment both before and after your intended use. We have included both High Pressure and Low Pressure Systems as they slightly differ.
To determine whether you have a High Pressure or Low Pressure system, first determine what type of tank you have by matching it with the images shown on our CO2 Options & Info Sheet.
Options below marked with an are generally for mobile applications and are optional on fixed or permanent systems that are not mobile or will be used again in same location.
A High Pressure System is most commonly used today for its various tank sizes and its affordability, but is not the only system available. If your tanks match any one of those pictured above under the “High Pressure” category, please follow this quick reference guide before and after use.
Before use
- *Connect hose to CO2 tank(s).
- Ensure the hose is connected and attached to the corresponding unit (Cryo Gun, CO2 Jet, etc.)
- Ensure all connections to tank(s) are tight and secure.
- Slowly turn on CO2 at tank(s) by twisting valve counter-clockwise to start flow of CO2
- Check connections between hose/tank(s) and hose/unit for leaks. Immediately turn off valve on CO2 Tank(s), by twisting clock-wise, if you notice major leaks. Contact CryoFX at this point.
- Depress handle on Cryo Gun or activate CO2 Jet until white fog ejects. (Note: this may take 2-6 sec onds before appearing as the hose is clearing out air first)
- Once white fog comes out, continue to use. (Note: after a period of time without use, you may experi ence a few seconds of no fog when using again on the first use after this period of time. This is normal as some of the liquid CO2 has turned to gas already towards the end of the hose closest to where the CO2 is ejected.)
- Strictly adhere to all safety guidelines and Dos and Don’ts which can be found at www.CryoFX.com under “Product Knowledge” tab.
After Use
- Return to tank(s) and turn off valve by twisting clock-wise until completely closed.
- Return back to Cryo Gun or CO2 Jet and depress handle/activate unit, as you would with normal opera tion, until all pressure is released from the system. (Note: After a few seconds of doing this, you will ex perience no white fog coming out but air still discharging. This is normal as the liquid has already turned into gas inside the hose and still needs to be cleared from the system. This may be loud at times.)
- *Once all pressure is released, disconnect hose from Cryo Gun/CO2 Jet.
- *Disconnect hose from CO2 tank(s).
• More info and products please visitwww.CryoFX.com •
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>