CryoFX Cryo Gun Handheld CO2 Cannon User Manual
- June 5, 2024
- CryoFX
Table of Contents
CryoFX Cryo Gun Handheld CO2 Cannon
SPECFICATION
- Dimensions: 19″ x 2″ x 8″ (48cm x 5cm x 20cm)
- Distance:
- 0-35 feet (Om-10.6mn)
- 2.7 pounds (1.2 Kg)
- Weight:
- PSI Rating: 0-2250 (0-155 bar)
- Material:
- Erye
- ABS/Brass/Steel
- Noise Level: 110 decibels
- Color:
- Voltage:
- Hardware:
- Black
- N/A
- 2250 psi Hose with attached Co2 tank connector fitting.
- Description: This is the handheld version of the most popular Cryo Jet
- you may have seen at nightclubs or concets. This CryoFX Cryo-Gun
- shoots a cloud of CO2 up to 25-35 feet wherever the operator wants it.
- This unit is used in Nightclubs, Bars, Concerts, DU Booths and more.
INSTALLATION
- Unpack CryoFX Cryo-Gun and Hose. Find end of hose that has fitting pictured below. Pull back the outside part (ring) of the fitting and insert the Cryo-Gun as shown below. Let go of ring as it should snap back forward. You may need to push the Cryo-Gun and hose together for the ring to snap forward. This will lock the Cryo-Gun and hose together. Pull Cryo-Gun and hose apart to make sure the Cryo-Gun is attached to the hose.
- Take other end of hose with the fitting shown below. Take the piece of tape off the top of the fitting and throw it away. Make sure the plastic O-ring stayes inside the fitting. crew fitting onto tank with your hand until it’s tight. Then take an adjustable wrench, as shown below, and tighten the fitting onto the tank fairly tight.
- SLOWLY turn the valve on top of the tank. The hose may move as the liquid CO2 enters the hose and makes it stiff. Check for any leaks you may see as you open the valve more.lf you notice leaks, turn off the valve.
- Grab the Cryo-Gun and slowly squeeze inner handle to spray C02. Make sure you have a firm grip as the Cryo-Gun may slip out of your hand while spraying. When finished using, turn valve on top of tank in opposite direction as the last time you turned it so as to close the valve. Return to Cryo-Gun and squeeze handle to let the remaining CO2 in the hose out.
Is there a warranty on this Cryo Gun?
Yes, there is a lifetime limited warranty which will cover operational and
mechanical defects only.
Can I disconnect the Crye Gun from the hose during use?
NO, never disconnect the Cryo Jet from the hose while there is pressure in the
line or the valve is in the on position on the Co2 bottle.
Are tools needed before I use this Cryo Gun?
Yes. one crescent wrench or adjustable wrench is needed to connect the hose to
the CO2 tank.
What kind of tank or bottle do I need?
You need one of two tanks. The most standard of the two tanks needed is a 50
pound high pressure Carbon Dioxide COJ siphon tube tank, also called a “Siphon
Tank” or “Dip Tube Tank”. The siphon tank has a tube that drops aown the
center to the bottom of the tank to dispense the liquid CO2 Make sure you ask
for a Siphon tank as a standard CO2 tank will not work. The alternative type
of tank used is a Dewar tank, which is a larger low pressure refrigerated tank
containing much more CO2 but at a lower pressure of 350psi or less ..
Where can I buy Carbon Dioxide, also called CO,?
You can find CO? gas at a local welding supply shop or Gas supplier {not the
gas you put in your car). AIRGAS is a national company which provides CO2
How long will the tanks last?
This varies a little on the length of the hose, the length of the blasts and
the tank you are using (50 pound High Pressure CO? Siphon or Low Pressure
Dewar). The average blast is 2 seconds long, so a High Pressure 50 pound
Sipnon Tank has 1.5 min of effect and a Low Pressure Dewar Tank has about 10
minutes of effect.
Can CO2 cool down an area?
Yes. between 20-35% depending how it is used. A solid stream is colder
directly in front than it is towards the outside of the stream of the blast.
What is a good hose length for my Cryo Gun?
The best length for the hose is between 20 feet and 30 feet. Any hose longer
than 50 feel will not work as effeciently as a shorter hose therefore
minimizing the output of the effect.
Can I connect multiple hoses or order longer hoses?
Yes. we can custom make any size hose with any number of quick connect
fittings or standard fittings so you have the future option to shorten or
lengthen your hose. We can also create custom hoses for two or more Cryo Gun
to run off the same tank or one Cryo Gun to run off multiple tanks. Please
email with any inquiries.
How far or how high do the plumes (clouds) of CO travel when exiling the
Cryo Gun?
The CO2 plumes will reach at least 20 feet to 30 feet. The humidity in the air
directly affects the visibility in relation to length and density of the CO2
cloud. The more the hum1d1ty, the better and farther the white cloud of CO2
can be seen.
Is it dangerous to shoot the CO directly at people?
Yes. CO2 displaces oxygen therefore making it very difficult to breath in the
immediate path of the CO2 plume cloud. Avoid spraying it directly at people
who are closer than 6 feet in distance. CO2 is also very cold, up to -40
Degrees F. and could easily freeze skin and body parts.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>