RADIANT T21 Beacon Device Instruction Manual
- June 5, 2024
- Radiant
Table of Contents
T21 Beacon Device
Instruction Manual
INTRODUCTION
Radiant’s “Bluetooth Beacon T21” RAD MEDIA-BLE-T21, subsequently identified
with the terms “product,” “device,” or “beacon”) is a Bluetooth Low Energy
(BLE) beacon primarily used for Industrial Asset Tracking solutions. Radiant’s
beacons utilize iBeacon(TM) technology or Eddystone(TM) format specifications
with proprietary firmware.
Before you start using a beacon device, verify that it is undamaged and
carefully read the instructions in this user manual, particularly the
indications in the “Safety” section.
Radiant RFID disclaims any liability if the devices are used in modes and
environments incompatible with keeping the product intact, safe, and in
operation.
PROCEDURES
Beacon Activation
The battery-powered T21 beacon ships in an activated state. An interior LED
briefly flashes red when the battery level is below 20%.
Beacon Use
The T21 beacon transmits adverting frames according to the default settings.
To modify beacon configurations, please get in touch with Radiant Support:
support@radiantrfid.com
Maintenance
The T21 beacon does not have a replaceable battery. Once the battery is
drained, and the beacon does not transmit advertising frames anymore, it
should be disposed of.
The beacon must never be opened or cut into. The beacon also must not be
exposed to any chemicals.
SAFETY
This information is an integral and essential part of the product (beacon) and
must be delivered to the user.
Please read carefully, as it contains important installation, use, and
maintenance information.
Warnings
- DISPOSE OF BADGE AFTER BATTERY IS DRAINED. THE BADGE DOES NOT HAVE A REPLACEABLE BATTERY.
The beacon must be intended for the use in which it was designed. Any other
use is considered improper and, therefore, dangerous.
Before you start using the beacon, verify that it is undamaged.
The beacon is a wireless device. Please be attentive in its use while in range
(less than 5 cm) of a pacemaker or other electronic medical life-saving
devices, as it transmits radio waves that can interfere with the proper
functioning of these devices. Contact the medical device manufacturer for more
information.
The company Radiant RFID disclaims any liability for damages caused by
inadequate use of the device and the failure to observe the information
provided herein.
DISCLAIMER
This manual is intended to provide a summary of our knowledge and some
guidance regarding the use of the beacon. The information is accurate to the
company’s best knowledge (Radiant RFID). This sheet is not intended to be an
inclusive document on worldwide hazard communication regulations. The
information is provided in good faith. Each user of this material needs to
evaluate the conditions of use and define the appropriate protective
mechanisms to prevent the exposure of persons, property damage, or release to
the environment.
Radiant RFID assumes no responsibility for injury to the recipient or third
persons or for any damages resulting from the misuse of the device and its
parts.
PRODUCT SPECIFICATIONS & MARKINGS
| Manufacturer | Radiant RFID |
|---|---|
| Manufacturer’s Part Number | READ MEDIA-BLE-T21 |
| IP Rating | -20°C to +60°C |
| Disposal | • DISPOSE OF THE BEACON AFTER THE BATTERY IS DRAINED. THE BADGE DOES |
NOT HAVE A REPLACEABLE BATTERY.
SUBSTITUTION OF COMPONENTS MAY IMPAIR SAFETY
Battery| Type: CR2477, Primary Lithium Battery
Enclosure Material| Polycarbonate
FCC STATEMENT
-
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. -
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Radiant RFID LLC, Confidential
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>