Wicked Audio WITW3550 RANGR True Wireless Earbuds-Complete Features/Instruction Guide

: June 5, 2024
: WICKED AUDIO

Wicked Audio WITW3550 RANGR True Wireless Earbuds

Wicked-Audio-WITW3550-RANGR-True-Wireless-Earbuds-imgg

Specifications

DRIVER: 10mm Neodymium
SENSITIVITY: 99 dB
FREQUENCY: 20-20,000 Hz
BLUETOOTH RANGE: 32 ft
EARBUD BATTERY LIFE: up to 10 hours
TOTAL PLAYTIME: Up to 50 hours
CHARGE TIME: 5 hour

Introduction

The Wicked true wireless earbuds come with a number of features including easy pairing and a 99 dB sensitivity. The earbuds come with triple battery protection and enhanced bass. They come with a charging case and take about 1.5 hours to be charged completely. They produce high-fidelity sound with noise isolation technology. They have a waterproof rating of IPX4 which means they provide resistance against sweat. They have a battery life of 10 hours and a total playtime along with the charging case is 50 hours.

Wicked-Audio-WITW3550-RANGR-True-Wireless-Earbuds-
fig-1

ONLY ONE EARBUD CONNECTING TO A DEVICE AT A TIME?

Sync earbuds together by following the steps below:

Forget all “Wicked Ranger” in your device’s Bluetooth settings.
Turn off the Bluetooth setting on your device.
Replace both earbuds back into the charging case. This will reset the earbuds.
Remove earbuds from the charging case. The earbuds will turn on and sync together automatically.
Turn Bluetooth back on your device.
Find/Select “Wicked Ranger” on your device.

OR

Forget all “Wicked Ranger” in your device’s Bluetooth settings.
Turn off the Bluetooth setting on your device.
With both earbuds in the charging case, remove one earbud and press the button 5 times.
Return earbud to charging case.
Remove another earbud from the charging case and press the button 5 times.
Return earbud to charging case. This will clear the earbuds’ memory.
Remove earbuds from the charging case. The earbuds will turn on and sync together automatically.
Turn Bluetooth back on your device.
Find/Select “Wicked Ranger” on your device.

CHARGING THE CASE

To charge the Charging Case use the included USB-C to the USB charging cord. Connect the USB-C (smaller side) into the Charging Case and connect the USB side to the computer or USB wall charger (not included).

FUTURE USE AFTER INITIAL PAIRING TO YOUR DEVICE

Remove earbuds (they will sync to each other automatically)
Earbuds will automatically pair to the last device it was paired to.

(If this is the ﬁrst time the earbuds are being paired to your Bluetooth device, or if the earbuds were “forgotten”, please see “First Time Use for Dual Earbud Use” section) (If you want to use a single earbud, please refer to section “First Time Use for Single Earbud Use”)

TURNING ON EARBUDS

There are two ways to turn on the earbuds:

Remove earbuds from their charging case.

OR

Hold buttons on both earbuds for 3 seconds. (This is when the earbuds have shut down outside of the charging case.)

TURNING OFF EARBUDS

There are two ways to turn off the earbuds:

Place earbuds back into their charging case. They will automatically turn off.

OR

Hold buttons on both earbuds for 5 seconds. You will hear a shutdown beep.

DISCONNECTED

When out of range, or if your device becomes disconnected from the earbuds, the earbuds will automatically go into pairing mode, announcing “disconnected”.
CHARGING CASE STATUS LIGHTS: Charging: FLASHING BLUE Fully Charged: SOLID BLUE
EARBUD STATUS LIGHTS ON CHARGING CASE: Charging: SOLID BLUE Fully Charged – TURNS OFF

CHARGING THE EARBUDS

Delicately place the earbuds into the earbud charging nests. Make sure each earbud is placed in its corresponding nest. A small magnetic pull will help the earbuds fall into the correct position. LEDs on the Charging Case will turn off when the earbuds are fully charged. The charging case will shut down automatically when the earbuds reach full charge or when both the earbuds are removed from the case.

FIRST TIME USE FOR DUAL EARBUD MODE

(If you want to use a single earbud, please refer to section “First Time Use- For Single Earbud Use”.)

Make sure the earbuds are charged (Please refer to the section “Charging the Earbuds”) any the Bluetooth device (Phone, computer, tablet etc.) is turned on with the Bluetooth feature enabled (this is usually found in settings).
Remove charged earbuds from the charging case. They will turn on and sync together automatically announcing “Power On.”
Both earbuds will sync together and then begin searching for a device to pair to, announcing “pairing.”
When in dual earbud mode, either earbud can act as the “communicator.”
Your device will detect the pairing name “Wicked Ranger”. Select “Wicked Ranger” on your device to start pairing to your device.
Both earbuds will announce “connected” when paired with your device.
You’re ready to go!

PAUSE/PLAY

When both earbuds are paired to your device you can pause and play your music by using a short press on the button with either the left or right earbud. (Please note when using BOTH earbuds, you can perform this function using EITHER earbud.)

NEXT/PREVIOUS

Next – Double Press button on Right Earbud
Previous – Double Press button on Left Earbud

ANSWER/HANGUP
When both earbuds are connected, answer or hang up by using a short press on the center button on either the left or right earbud.

INCOMING CALL
When receiving an incoming call, the earbuds will detect the device’s programmed ringtone (this may differ depending on your device) You can answer by using a short press on the button on either the left or right earbud.

LOW BATTERIES

Please consider charging your earbuds regularly when not in use to retain ample battery life in both earbuds. When the earbuds have approximately 10% battery life the earbuds will announce “Low Charge.” After around 8 minutes the earbud will repeat the announcement and then shut off.

PRECAUTIONS

LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE.
Overexposure to excessive sound, levels can damage your ears resulting in permanent noise-induced hearing loss
(NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.

SAFE USE & HAZARD WARNINGS

90 dB SPL at 8 hours, 95 dB SPL at 4 hours, 100 dB SPL at 2 hours, 105 dB SPL at 1 hour, 110 dB SPL at 30 min, 115 dB SPL at 15 min, 120 dB SPL: Avoid as damage that may occur

Limitation of Liability Any Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. In no event, under any cause of action of a theory of liability, shall Wicked Audio Inc., its distributors or suppliers be liable to you or any third party for indirect, incidental, consequential, special, exemplary or punitive damages, of any and all nature whatsoever, arising out of the use of or inability to use a product. This includes without limitation, property damage, loss of value of the product or any third-party products that are used in or with the Wicked Audio products, even if the Wicked Audio product has been advised of the possibility of such damages that one may encounter.

Without limiting the foregoing, you understand and agree that Wicked Audio has no liability for any damages or destruction to the consumer electronics devices or other personal property that are contained in inside or outside the Wicked Audio products. This includes without limitation, laptops, cellular phones, or other hand-held devices, or any loss of data contained on the foreign device. Notwithstanding any damages that you might incur for general damages in contract, tort (including negligence) or otherwise), the entire aggregate liability of Wicked Audio and any of its distributors and/or suppliers shall be limited to the amount actually paid by you for the Wicked Audio product giving rise to liability. Some states and/or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. The limitations of liability set forth above shall apply to the maximum extent permitted under applicable law.

IMPORTANT SAFETY INSTRUCTION

Read these instructions.
Keep these instructions.
Heed all warnings
Follow all instructions.

Attention should be drawn to the environmental aspects of battery disposal; The use of apparatus in moderate climates

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

FREQUENTLY ASKED QUESTIONS

Are Wicked Audio waterproof?
Yes, they are sweat proof.
How long do wicked wireless headphones take to charge?
They take about 1.5 hours to charge completely.
How do you charge Wicked Audio?
They can be charged by placing them in the charging case.
Can I use one earbud at a time? Or can the left earbud work alone?
Yes, one earbud can be used at a time.
Will phone call audio play thru both ears or only the right ear?
The audio from the call plays on both ears.
Does it have a mute button?
No, the earbuds don’t have a mute button.
How can I turn off the earbuds?
The earbuds can be turned off by simply placing them in the charging case.
What is the Bluetooth range of the earbuds?
The earbuds have a range of 33 ft/10 meters.
Do the earbuds come with a waterproof rating?
Yes, they come with a waterproof rating of IPX4.
Are there any battery level indicators?
Yes, they come with LED indicators that tell the battery status.