WICKED AUDIO WI-TW3550 Ranger True Wireless Earbuds Instruction Manual
- June 5, 2024
- WICKED AUDIO
Table of Contents
- WICKED AUDIO WI-TW3550 Ranger True Wireless Earbuds
- EARBUDS
- ONLY ONE EARBUD CONNECTING TO A DEVICE AT A TIME?
- CHARGING THE CASE
- CHARGING THE EARBUDS
- FIRST TIME USE FOR DUAL EARBUD MODE
- FUTURE USE AFTER INITIAL PAIRING TO YOUR DEVICE
- TURNING ON EARBUDS
- FIRST TIME USE FOR SINGLE EARBUD USE
- PRECAUTIONS
- IMPORTANT SAFETY INSTRUCTION
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
WICKED AUDIO WI-TW3550 Ranger True Wireless Earbuds
EARBUDS
ONLY ONE EARBUD CONNECTING TO A DEVICE AT A TIME?
Sync earbuds together by following the steps below:
- Forget all “Wicked Ranger” in your device’s Bluetooth settings.
- Turn off the Bluetooth setting on your device.
- Replace both earbuds back into the charging case. This will reset the earbuds.
- Remove earbuds from the charging case. The earbuds will turn on and sync together automatically.
- Turn Bluetooth back on your device.
- Find/Select “Wicked Ranger” on your device.
OR
- Forget all “Wicked Ranger” in your device’s Bluetooth settings.
-
- Turn off the Bluetooth setting on your device.
- With both earbuds in the charging case, remove one earbud and press the button 5 times.
- Return earbud to charging case.
- Remove another earbud from the charging case and press the button 5 times.
- Return earbud to charging case. This will clear the earbuds’ memory.
- Remove earbuds from the charging case. The earbuds will turn on and sync together automatically.
- Turn Bluetooth back on your device.
- Find/Select “Wicked Ranger” on your device.
CHARGING THE CASE
To charge the Charging Case use the included USB-C to the USB charging cord. Connect the USB-C (smaller side) into the Charging Case and connect the USB side into the computer or USB wall charger (not included).
CHARGING CASE STATUS LIGHTS:
Charging: FLASHING BLUE
Fully Charged: SOLID BLUE
EARBUD STATUS LIGHTS ON CHARGING CASE:
Charging: SOLID BLUE
Fully Charged – TURNS OFF
CHARGING THE EARBUDS
Delicately place the earbuds into the earbud charging nests. Make sure each earbud is placed in its corresponding nest. A small magnetic pull will help the earbuds fall into the correct position. LEDs on the Charging Case will turn off when the earbuds are fully charged. The charging case will shut down automatically when the earbuds reach full charge or when both the earbuds are removed from the case.
FIRST TIME USE FOR DUAL EARBUD MODE
(If you want to use a single earbud, please refer to section “First Time Use- For Single Earbud Use”.)
- Make sure the earbuds are charged (Please refer to the section “Charging the Earbuds”) and the Bluetooth device (phone, computer, tablet etc.) is turned on with the Bluetooth feature enabled (this is usually found in settings).
- Remove charged earbuds from the charging case. They will turn on and sync together automatically announcing “Power On.”
- Both earbuds will sync together and then begin searching for a device to pair to, announcing “pairing.”
- When in dual earbud mode, either earbud can act as the “communicator.”
- Your device will detect the pairing name “Wicked Ranger”. Select “Wicked Ranger” on your device to start pairing to your device.
- Both earbuds will announce “connected” when paired with your device.
- You’re ready to go!
FUTURE USE AFTER INITIAL PAIRING TO YOUR DEVICE
- Remove earbuds (they will sync to each other automatically)
- Earbuds will automatically pair to the last device it was paired to.
(If this is the first time the earbuds are being paired to your Bluetooth device, or if the earbuds were “forgotten”, please see “First Time Use for Dual Earbud Use” section)(If you want to use a single earbud, please refer to section “First Time Use For Single Earbud Use”)
TURNING ON EARBUDS
There are two ways to turn on the earbuds:
- Remove earbuds from their charging case. OR
- Hold buttons on both earbuds for 3 seconds. (This is when the earbuds have shut down outside of the charging case.)
TURNING OFF EARBUDS
There are two ways to turn off the earbuds:
-
Place earbuds back into their charging case. They will automatically turn off.
OR -
Hold buttons on both earbuds for 5 seconds. You will hear a shutdown beep.
DISCONNECTED
When out of range, or if your device becomes disconnected from the earbuds,
the earbuds will automatically go into pairing mode, announcing
“disconnected”.
PAUSE/PLAY
When both earbuds are paired to your device you can pause and play your music
by using a short press on the button with either the left or right earbud.
(Please note when using BOTH earbuds, you can perform this function using
EITHER earbuds.)
NEXT/PREVIOUS
Next – Double Press button on Right Earbud
Previous – Double Press button on Left Earbud
ANSWER/HANGUP
When both earbuds are connected, answer or hang up by using a short press on
the center button on either the left or right earbud.
INCOMING CALL
When receiving an incoming call, the earbuds will detect the device’s
programmed ringtone (this may differ depending on your device) You can answer
by using a short press on the button on either the left or right earbud.
LOW BATTERIES
Please consider charging your earbuds regularly when not in use to retain
ample battery life in both earbuds. When the earbuds have approximately 10%
battery life the earbuds will announce “Low Charge.” After around 8 minutes
the earbud will repeat the announcement and then shut off.
FIRST TIME USE FOR SINGLE EARBUD USE
- Remove one earbud; keep the other earbud in the charging case 2a If earbuds have previously been connected to your device, either earbud will automatically pair to your device in single-mode
2b If this is your first time connecting these earbuds to your device, “Wicked Ranger” will appear in your Bluetooth Settings menu. Pair to “Wicked Ranger”
Note: To return to “Dual Earbud Mode” Remove the second earbud from the
charging case and it will automatically sync to your other earbud and pair to
your device
Note: To switch from “Dual Earbud Mode” to “Single Earbud Mode” Place
either earbud into the charging case or turn it off by holding the down button
for 5 seconds. The other earbud will continue working with your device.
PRECAUTIONS
LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE.
USE AS LOW A VOLUME AS POSSIBLE.
Overexposure to excessive sound levels can damage your ears resulting in
permanent noise-induced hearing loss (NIHL). Please use the following
guidelines established by the Occupational Safety Health Administration (OSHA)
on maximum time exposure to sound pressure levels before hearing damage
occurs.
SAFE USE & HAZARD WARNINGS
90 dB SPL at 8 hours, 95 dB SPL at 4 hours, 100 dB SPL at 2 hours, 105 dB SPL
at 1 hour, 110 dB SPL at 30 min, 115 dB SPL at 15 min, 120 dB SPL: Avoid
damage may occur
USO SEGURO DE PELIGROS Y ADVERTENCIAS
90 dB SPL a 8 horas, 95 dB SPL a 4 horas 100 dB SPL a 2 horas, 105 dB SPL a 1
horas, 110 dB SPL a 30 minuto, 115 dB SPL a 15 minuto, 120 dB SPL: Evite que
se puede producir daños
Limitation of Liability Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment. The device has been evaluated to meet general RF
exposure requirements. The device can be used in portable exposure conditions
without restriction. In no event, under any cause of action of a theory of
liability, shall Wicked Audio Inc., its distributors, or suppliers be liable
to you or any third party for indirect, incidental, consequential, special,
exemplary, or punitive damages, of any and all nature whatsoever, arising out
of the use of or inability to use a product. This includes without limitation,
property damage, loss of value of the product or any third party products that
are used in or with the Wicked Audio products, even if the Wicked Audio
product has been advised of the possibility of such damages that one may
encounter. Without limiting the foregoing, you understand and agree that
Wicked Audio has no liability for any damages or destruction to the consumer
electronics devices or other personal property that are contained in inside or
outside the Wicked Audio products. This includes without limitation, laptops,
cellular phones, or other hand-held devices, or any loss of data contained on
the foreign device. Notwithstanding any damages that you might incur for
general damages in contract, tort (including negligence) or otherwise), the
entire aggregate liability of Wicked Audio and any of its distributors and/or
suppliers shall be limited to the amount actually paid by you for the Wicked
Audio product giving rise to liability. Some states and/or jurisdictions do
not allow the exclusion or limitation of incidental or consequential damages,
so the above limitations or exclusions may not apply to you. The limitations
of liability set forth above shall apply to the maximum extent permitted under
applicable law.
IMPORTANT SAFETY INSTRUCTION
- Read these instructions.
- Keep these instructions.
- Heed all warnings
- Follow all instructions.
Attention should be drawn to the environmental aspects of battery disposal;
The use of apparatus in moderate climates
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>