finder IB152KEN Channel Universal Dimmer Instructions

June 3, 2024
finder

SWITCH TO THE FUTURE
15.2K
Instructions Manualfinder IB152KEN Channel Universal
Dimmer

IB152KEN Channel Universal Dimmer

15.2K.8.230.0400

IN| BUS KNX 29 V DC
(21…32 V DC) SELV
Pmax| 2 x 400 W max
| LED| (230 V AC) 100 W
| (230 V AC) 400 W
| (230 V AC) 400 W
| (230 V AC) 100 W
| (230 V AC) 400 W
| (–5…+45)°C
IP20

finder IB152KEN Channel Universal Dimmer - FIGURE 1Utility Model – IB152KVXX – 11/19
FINDER S.p.A. con unico socio – 10040 ALMESE (TO) – ITALY

finder IB152KEN Channel Universal Dimmer - FIGURE 2finder IB152KEN Channel Universal Dimmer - FIGURE
3

15.2K DIMMER KNX (2 channels)

FRONT VIEW

1a Channel 1 (CH 1)
1b Channel 2 (CH 2)
1c Button for manual increase
1d Green LED, output ON
1e Red LED, overload
1f Buttons for manual decrease
1g Power supply via KNX BUS
1h PROG: press the button to enter programming mode (Red LED ON)
1i TEST: test button. Press the button for 3 seconds (yellow LED flashes) to enable the 1C / 1F outputs keyboard.
To disable it, press the button once (yellow LED OFF).
After enabling the manual function with the TEST key, with the UP(+)/DOWN(–) keys of the individual channels it is possible to switch on the lights in steps of 30%. During the TEST mode, the command telegrams from the bus are ignored

WIRING DIAGRAM

PRODUCT FEATURES

  • Leading Edge or Trail Edge adjustment method settable by ETS 4
  • Manual control of each channel via the front panel
  • Thermal protection and short circuit protection
  • Scenario management
  • ID LED for each output

NOTE

  • The product must not be used for safety functions
  • Environmental class according to EN 50491-2: Protected by the climate in uncontrolled conditions, temperature –25…+45°C
  • Check the correct address of the device and the setting of the parameters, via ETS software
  • EN 60669-1 and 60669-2-1/EN 50491
  • 35 mm bar mounting (EN60715)
  • Width 70 mm (4 modules)

CAUTION
The individual dimmer channels and the BCU are supplied separately, in case of a non-simultaneous power supply an initialization time that can last up to 20“ is required.
During this phase, the commands received will not be considered.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals