eufy W31 Wet Dry Vacuum Cleaner User Manual
- June 5, 2024
- Eufy
Table of Contents
W31 Wet Dry Vacuum Cleaner
User Manual
How to Install the Handle Bar after Unboxing
After unboxing WetVac W31, you’ll need to install the handlebar.
A. The handlebar is in the correct position when you hear a click.
B. Check if the handlebar is securely in place.
C. Check the unlock hole.
D. Lift WetVac W31 by the handlebar to make sure it remains connected to the
main unit.
Also, the handlebar can be removed if you need to store it. Please turn off
WetVac W31 first. Inset a pen or other small tool into the unlock hole to
release. Then pull the handlebar up.
If you need further assistance, please contact eufy customer support.
What to do if the voice prompt is too loud
WetVac W31 supports low volume levels and standard volume levels. You can
adjust volume according to your needs. Below are the instructions:
The voice prompt defaults to a low volume level.
Hold the self-cleaning button for 3 seconds to enter the standard volume
level. Hold the self-cleaning button for 3 seconds again to turn off the voice
prompts.
Hold the self-cleaning button for 3 seconds one more time to enter the low
volume level.
If you need further assistance, please contact eufy customer support.
Will the WetVac self-clean everything
No, it will self-clean and auto dries its rolling brush. After cleaning,
simply put the WetVac back onto the charging station and press the self-
cleaning button, and WetVac will start self-cleaning. The whole process will
take 3 minutes and you will hear a prompt voice when the self-drying is
complete.
Note before self-clean:
Make sure the clean water tank level is more than 50% Make sure the battery
level is higher than 30%
It is recommended to follow the voice prompts to clean and clean the dirty
water tank after each use. Also, please rinse and dry the sponge filter and
rolling brush regularly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>