BOSCH AHM 30 Mower Spindle Knife Instruction Manual
- June 3, 2024
- Bosch
Table of Contents
Operating Instructions
AHM 30/AHM 38
AHM 30C/AHM 38C
Safety Notes
**** Read the instructions carefully.
Never mow while people, especially children or pets, are nearby. Walk, never
run.
Do not operate the mower when barefoot or wearing open sandals.
Thoroughly inspect the area where the appliance is to be used and remove all
objects, which may be thrown by the machine.
Always be sure of your footing on slopes. Do not mow excessively steep slopes.
Keep all nuts, bolts, and screws tight to be sure that the lawnmower is in
safe working condition.
Replace worn or damaged parts for safety.
Be careful during the adjustment of the machine to prevent entrapment of the
fingers between moving blades and fixed parts of the machine.
Product Specification
| Cylinder Mower | AHM 30 | AHM 38 | AHM 30C | AHM 38C |
|---|---|---|---|---|
| Part number | 0 600 886 001 | 0 600 886 101 | 0 600 886 002 | 0 600 886 102 |
| Blade width | 30 cm | 38 cm | 30 cm | 38 cm |
| No Cylinder Blades | 4 | 4 | 5 | 5 |
| Height of cut | 12 – 40 mm | 12 – 40 mm | 15 – 43 mm | 15 – 43 mm |
| Weight | 5.6 kg | 7.3 kg | 5.8 kg | 7.5 kg |
Intended Use
This product is intended for domestic lawn mowing.
Introduction
This manual gives instructions on the correct assembly and safe use of your
machine. It is important that you read these instructions carefully.
When fully assembled the machine weighs approximately 5.6 kg – 7.5 kg. If
necessary, obtain assistance to remove it from the packaging. Take care when
carrying the mower to the lawn, as the blades are sharp.
Delivered Items
Carefully remove the machine from its packaging and check that you have all
the following items:
– Lawnmower
– Bottom handle
– Top handle
– 2 Handle Centres
– 6 Nuts
– 6 Bolts
– Operating instructions
When parts are missing or damaged, please contact your dealer.
Assembly
A. Attach bottom handle 1 to the mower.
B. assemble the top handle 2 to the handle cen- tres 3, and fit to handle
bottom 1.
C. Adjusting the Cutting Height
D. Coarse:
The roller brackets 4 should be set in one of three positions according to the
type of lawn: I for high range for bumpy lawns, II for medium range for
average lawns and III fore low range for reasonably flat lawns. You should
only need to make this adjustment once, thereafter use the „Fine“ adjustment
to cut longer or shorter grass.
To change the height of the cut:
- Remove the wingnut 5 and bolt.
- Reposition the bolt for the required height of the cut.
- Refit wingnut 5.
D. Fine (X):
Slacken wing nut 5 on both sides of the mower. Move both roller brackets 4.
equally to the required height of cut.
E. Mowing
For best results, place the lawnmower on the edge of the lawn, and mow in a
forward direction. Reverse at the end of each turn, slightly overlapping the
previous cut strip.
Maintenance
Note: To ensure long and reliable service, carry out the following
maintenance regularly.
Regularly check for obvious defects such as loose, dislodged or damaged
blades, loose fixings, and worn or damaged components. Check that covers and
guards are undamaged and correctly fitted. Carry out necessary maintenance or
repairs before using.
If the mower should happen to fail despite the care taken in manufacture and
testing, repair should be carried out by an authorized customer service agent
for Bosch garden products. For all correspondence and spare parts orders,
always include the 10-digit part number from the nameplate of the machine!
Adjusting the Blade
The cutting cylinder should be adjusted if the grass is not cut cleanly and
evenly.
Turn both adjuster knobs 7 clockwise a little at time until the cutting
cylinder 6 lightly brushes the bottom blade 8.
Note: The blades act like a pair of shears.
Accessories
Grassbox AHM 30/38C ……………… 0 600 886 060
Grassbox AHM 30/38C ……………… 0 600 886 160
After Mowing/Storage
Clean the exterior of the machine thoroughly using a soft brush and cloth. Do
not use water, solvents, or polishes. Remove all grass and debris.
Turn the machine on its side and clean the blade area. If grass cuttings are
compacted in the blade area, remove them with a wooden or plastic implement.
Store the lawnmower in a dry place. Do not place other objects on top of the
machine.
Guarantee
We guarantee Bosch appliances in accordance with statutory/country-specific
regulations (proof of purchase by invoice or delivery note).
Damage attributable to normal wear and tear, overload or improper handling
will be excluded from the guarantee.
In case of complaint please send the machine, undismantled, to your dealer or
the Bosch Service Centre for lawn and garden products.
Environmental Protection
The machine has been assembled in an environmentally responsible way.
Recycle raw materials instead of disposing as waste.
Machines, accessories and packaging should be sorted for environment-friendly
recycling.
These instructions are printed on recycled paper manufactured without
chlorine.
The plastic components are labelled for categorized recycling.
When the time comes to dispose of this product, please consider the
environment and take it to a recognized recycling facility (please contact
your local authority for location
information).
Service
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham-Uxbridge
GB-Middlesex UB 9 5HJ
✆ Service …………………………..+44 (0) 18 95 / 83 87 82
✆ Advice line ……………………. +44 (0) 18 95 / 83 87 91
Fax ………………………………………… +44 (0) 18 95 / 83 87 89
Ireland
Beaver Distribution Ltd.
Greenhills Road
IRL-Tallaght-Dublin 24
✆ Service ……………………………….. +353 (0)1 / 414 9400
Fax ……………………………………………… +353 (0)1 / 459 8030
Australia
Robert Bosch Australia L.t.d.
RBAU/SPT2
1555 Centre Road
P.O. Box 66 Clayton
AUS-3168 Clayton/Victoria
✆ ………………………………………….. +61 (0)1 / 800 804 777
Fax ………………………………………….. +61 (0)1 / 800 819 520
www.bosch.com.au
E-Mail:
CustomerSupportSPT@au.bosch.com
New Zealand
Robert Bosch Limited
14-16 Constellation Drive
Mairangi Bay
Auckland
New Zealand
✆ ……………………………………………….. +64 (0)9 / 47 86 158
Fax ……………………………………………….. +64 (0)9 / 47 82 914
Subject to change without notice
Robert Bosch GmbH
Geschäftsbereich Elektrowerkzeuge
D-70745 Leinfelden-Echterdingen
www.bosch-pt.com
F016 L69 768 (01.02) O / 48
Printed in England
References
- Invented for life | Bosch Global
- VerinaTEC – Sabedoria para o negócio!
- Startseite | service.co.at
- Location selection | Bosch Power Tools
- Home | Bosch in Australia
- Home | Bosch in Italia
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>