eta Verto X442 Handheld Bagless Vacuum Cleaner Instruction Manual
- June 5, 2024
- ETA
Table of Contents
- eta Verto X442 Handheld Bagless Vacuum Cleaner
- SAFETY WARNING
- EQUIPMENT AND ACCESSORIES
- VACUUM CLEANER PREPARATION
- USE OF VACUUM CLEANER
- REMOVING THE DUST CONTAINER AND FILTER
- CLEANING AND MAINTENANCE
- ENVIRONMENTAL PROTECTION
- TECHNICAL DATA
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
eta Verto X442 Handheld Bagless Vacuum Cleaner
INSTRUCTIONS FOR USE
Dear customer, thank you for purchasing our product. Please read the
operating instructions carefully before putting the appliance into operation
and keep these instructions including the warranty, the receipt and, if
possible, the box with the internal packing.
SAFETY WARNING
GENERAL PROVISIONS:
- Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.
- Check whether the data on the type label corresponds with the voltage in your socket. The adapter / power cord plug may only be connected to the electrical socket complying with the applicable standards.
- This appliance may only be used by children aged 8 years or older, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children younger than 8 years must be kept out of reach of the appliance and its power cord.
- Never use the appliance if its adaptor / power cord or plug is damaged, if it does not work properly, if it fell down and was damaged. In this case take the appliance to a special service to check its safety and proper function.
- Never immerse the adapter / charging stand, the battery and the motor part of the vacuum cleaner into water (even partially) and protect them against humidity!
- Always turn the appliance off before emptying the tank or before maintenance.
- Never leave the product unattended when in operation!
- Do not charge the battery if electrolyte is leaking from it.
- The appliance must be disconnected from the power adapter when removing the battery.
- Do not through the battery into fire. There is a risk of explosion!
- In order to ensure safety and proper function of the appliance, use only original spare parts and accessories approved by the manufacturer.
- Only use this appliance for the purpose it was designed for, as specified in this manual. Never use the appliance for any other purpose.
- The manufacturer is not responsible for damage caused by improper use of the appliance and the accessories and its warranty for the appliance does not apply in situations when the safety warnings above are not complied with. Failure to replace or maintain all filters regularly according to the instructions in Chapter IV., V., VI and also using non–original filters, the properties of which resulted in failure or damage of the vacuum cleaner, is also understood to be improper use of the appliance.
USE OF THE APPLIANCE:
- The product is intended for home use and similar (in shops, offices and similar workplaces, in hotels, motels and other residential environments, in facilities providing accommodation with breakfast). It is not intended for commercial use!
- Never use the vacuum cleaner nor touch the adaptor / charging stand with wet hands or feet!
- Never use (switch on) the vacuum cleaner if it is being charged!
- Always switch off the vacuum cleaner when charging the battery and after the vacuum cleaner was used.
- Do not vacuum sharp objects (e.g. glass, shatter), hot, flammable, explosive items (e.g. ash, hot cigarette butts, gasoline, thinners and aerosol vapours) or greases (e.g. fats, oils), caustic agents (e.g. acids, solvents). Vacuuming these objects may lead to damage of the dust filters or the vacuum cleaner.
- Pores of the micro filters may be clogged when vacuuming very fine dust. Thus, air permeability will be reduced and the suction performance will drop. In this case, micro–filters have to be cleaned before the container is full. Do not use the vacuum cleaner to vacuum dirt produced during/after construction such as plasterboard dust, fine sand, cement, dust from construction, parts
of plaster etc. If this dirt / loose construction materials / loose construction materials into the aggregate, it poses a danger of damage. The warranty repair does not cover this.
ACCESSORIES AND ASSEMBLY OF THE APPLIANCE:
Install the charging stand, the adapter, the vacuum cleaner and the appliance within sufficient distance from flammable objects (e.g. curtains, drapes, wood, etc.), heat sources (e.g. oven, stove, etc.) and wet surfaces (e.g. sinks, wash–basins etc.).
ADAPTER / POWER CORD:
- If the adaptor of the appliance is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person so as to prevent dangerous situations.
- WARNING: To charge the battery, use only the network adapter /charging stand supplied with this appliance.
- To power the appliance, only apply safe small voltage in accordance with the type plate.
- Use the adapter / charging stand in a room only.
- The adaptor / chanrging stand supplied with this appliance is intended for this appliance only, do not use it for other purposes.
- The power cord must not be damaged with sharp or hot objects, open fire, it must not be sunk into water or bent over sharp edges.
For trouble-free operation of the vacuum cleaner, please use the tested micro- filters recommended by the producer.
EQUIPMENT AND ACCESSORIES
- A – vacuum cleaner
- A1 – O/I switch
- A2 – charging signal lights
- A3 – container lock button
- A4 – handle
- B – dust container
- B1 – HEPA filter
- B2 – separator
- C – accessories
- C1 – crevice nozzle
- C2 – brush
- C3 – rubber scraper
- D – charging stand
- D1 – power cord
- D2 – opening for mounting on the wall
- D3 – space for small accessories (crevice nozzle, brush, rubber scraper)
- E – adapter
VACUUM CLEANER PREPARATION
Remove all packing material, take out the vacuum cleaner and the accessories. Remove all possible adhesion foils, stick-on labels or paper from the appliance.
VACUUM CLEANER ASSEMBLY
When assembling the vacuum cleaner, follow the procedure indicated in Fig. 1.
In accordance with the required use, choose suitable accessories (C1, C2, C3)
or use the vacuum cleaner without accessories C (Fig. 4).
CHARGING THE ACCUMULATOR
Turn the vacuum cleaner off prior to charging! Connect the adaptor to the
charging connector and plug it to the mains (ETA1442). According to Fig. 2,
place the vacuum cleaner on the charging stand and connect to the power supply
(ETA3442/ETA5442). The standard charging time is approx. 5 hours. The status
and progress of charging is indicated by indicator A2.
Charging signal lights (A2)
Flashing red (5x)
+ Lit in red
| Accumulator is charging.
Lit in green| Accumulator is charged.
Warning
- Let the vacuum cleaner recharge as soon as its suction performance is weaker.
- When using the vacuum cleaner for an extended period of time or in a hot environment, the accumulator might be too hot for charging. Let the accumulator cool down prior to charging.
Set power
| | Running Time *|
---|---|---|---
ETA1442| ETA3442| ETA5442*
MIN| Approx. 15 minutes| Approx. 15 minutes| Approx. 20 minutes
MAX| Approx. 6 minutes| Approx. 6 minutes| Approx. 7 minutes
Note:** The stated operating times are based on ETA‘s internal testing
and only apply to a new and fully charged battery. Depending on the age and
wear of the battery, the operating time decreases.
INSTALLING THE CHARGING STAND ON THE WALL
To install the charging stand D on the wall, use the holes D2 on its back.
Mount the charging stand D on the wall using a suitable connecting material.
Warning
- Make sure that the electric socket is sufficiently close to the mounted stand.
- Check that there is no electrical, telephone, water or other similar installation in the wall at the place of the mounting of the stand.
USE OF VACUUM CLEANER
Let the vacuum cleaner charge sufficiently prior to using.
CONTROL O/I switch (A1)
vacuum cleaner ON/OFF switch
Vacuuming dry impurities
Select the suitable accessories (C1, C2).
Vacuuming wet impurities
Rubber scraper C1 end–to–end to the hole in the dust container B. Push the
scraper slightly to the surface that you want to clean and hold the vacuum
cleaner tilted in the angle of about 30 degrees. Make sure that the scraper is
constantly in contact with the surface during vacuum cleaning.
Warning
- When vacuuming wet impurities, the vacuum cleaner cannot be turned with the dust container upside down, laid down or bent to one side or shaken.
- If the level of the liquid in the container reaches the maximum gauge (120 ml), stop vacuuming the liquid.
- After every use of the vacuum cleaner for vacuuming liquids or wet impurities empty and wipe thoroughly the container.
REMOVING THE DUST CONTAINER AND FILTER
DUST CONTAINER REMOVAL
When taking out the dust container B follow the procedure indicated in Fig. 1.
Dispose of dirt contained in the dust container with regular household waste.
An emptied and cleaned container is to be put back into the vacuum cleaner in
reverse order.
REPLACING THE HEPA FILTER
When removing the HEPA filter, proceed according to Fig. 1. Insert the
new/clean HEPA filter into the vacuum cleaner in a reverse order.
CLEANING AND MAINTENANCE
Warning
- The maximum suction effect can only be achieved with a clean HEPA filter and an empty dust container.
- We recommend cleaning the HEPA filter each time when the dust container is emptied.
- When vacuuming very fine dust, the HEPA filter pores may become clogged, which reduces air permeability and the suction performance. In this case, it is required to clean the HEPA filter even when the tank is not full.
Clean the surface of the vacuum cleaner, adapter and the charging stand with a soft damp cloth; do not use any rough and aggressive cleaning agents!
Accessories
After any vacuuming it is recommended to check visually the brushes or
collectors for possible impurities. If there are some impurities, remove them.
Dust container
Use a wet cloth to clean the surface of the container B. Rinse the inside of
the container B with water. Rinse the separator B2 under running water. Allow
all the parts to dry out properly before their re-use.
HEPA filter
Shake out the input HEPA filter B1 gently, or blow it out. If the HEPA
filter is very dirty, you can rinse it under running lukewarm water. Allow it
to dry out properly.
Caution
- If you clean the HEPA filter with water, its filtration properties will deteriorate. The filter cannot be washed more than three times. After that, a new filter needs to be purchased.
- We recommend that you replace the HEPA filter twice a year.
- The HEPA filter is not suitable for washing in the dishwasher.
- Failure to clean or replace the HEPA filter as required may cause a defect of the vacuum cleaner!
ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing, components and accessories as well as their recycling on all parts. The symbols specified on the product or in the accompanying documentation mean that the used electrical or electronic products must not be disposed of together with municipal waste. For proper disposal of the product, hand it over at special collection places where it will be received free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal. Fines can be imposed for improper disposal of this type of waste in agreement with the national regulations. The appliance is equipped with the Li-Ion battery with long life. For environmental protection it is necessary to remove the battery from the appliance after its service life and the battery and the appliance must be disposed of safely using special collection networks. Ask for more details at the local authority or at the local waste collection site.
Removing the accumulator
You can remove the accumulators from the appliance only after they have been
completely discharged (i.e. let the vacuum cleaner run until its motor stops).
Unscrew the screws and open the vacuum cleaner .
TECHNICAL DATA
Protection class (vacuum cleaner)
Accumulator (ETA1442/ETA3442/ ETA5442) 7.2 V / 10.8 V / 14.4 V Li-Ion
Weight (kg) approx. 0.9
Size of the product (mm) 415 x 120 x 120
Acoustic noise level of 78 dB(A) re 1pW
Charging adapter | ETA1442 | ETA3442 | ETA5442 |
---|---|---|---|
Manufacturer’s name or trademark, business registration number and address | |||
ETA | ETA | ETA | |
Model identifier | YH-S093V0900500 | YH-S093V1400400 | WJG-Y091800500W |
Input voltage | 100-240 V (AC) | 100-240 V (AC) | 100-240 V (AC) |
Input frequency | 50/60 Hz | 50/60 Hz | 50/60 Hz |
Output voltage | 9.0 V (DC) | 14.0 V (DC) | 18.0 V (DC) |
Output current | 0.5 A | 0.4 A | 0.5 A |
Output power | 4.5 W | 5.6 W | 9.0 W |
Average efficiency in active mode | 77.38 % | 80.10 % | 115 V: 82.18 %; |
230 V: 82.77 %
Low load efficiency (10%)| –| –| –
Power consumption without load| 0.07 W| 0.08 W| 115 V: 0.045 W
230 V: 0.060 W
Appliance protection class| II.| II.| II.
The manufacturer reserves the right to change the technical specifications and
accessories for the respective models.
Replacement of parts that require intervention in the electric part of the
appliance must be carried out by a specialized service! Failure to comply with
the instructions of the manufacturer will lead to expiration of the right to
guarantee repair!
WARNINGS AND SYMBOLS USED ON THE APPLIANCE, PACKAGING OR IN THE
INSTRUCTIONS MANUAL:
HOUSEHOLD USE ONLY; DO NOT IMMERSE IN WATER OR OTHER LIQUIDS; TO AVOID DANGER
OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT
USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.
Read operator’s manual
Removable power supply unit
The symbol indicates a WARNING.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>