DOAGEAS B80 Wireless Charger Bluetooth Speaker Instruction Manual
- June 5, 2024
- DOAGEAS
Table of Contents
B80
wireless charger bluetooth speaker
Please read the instruction manual before operating the wireless charger
bluetooth speaker
- Range of application
Main Function Instruction
Product Parameters
- Input:DC 5V/2A
- Audio Output Power:3W
- Wireless Power:5W
- SNR:≧90db
- Wireless Power Output:5V/1A
- Wireless Charging Standard: QI
- Built-in polymer-Li battery:300mAh
- Working time: about 1.5 hours
- Playing time: about 2 hours
Instructions
-
The red light is on when connecting the wireless charging Bluetooth speaker to the DC 5V / 2A adapter or another mobile power device.
-
Place the mobile phone or other mobile devices with the wireless receiver on the wireless charging panel of the wireless charging Bluetooth speaker and the mobile devices display the charging status.
-
If the mobile phone does not have a built-in wireless receiver you need to connect the phone to a wireless receiver board.
Then put it on the wireless charging panel, and the mobile phone displays the charging status. -
When the wireless charger is charging the mobile phone, the blue light is always on Play the Music In Bluetooth Speaker Mode:
-
shift the Bluetooth Speaker On/Off button to the ON option to begin the Bluetooth Speaker mode.
-
Open the Bluetooth function on your mobile phone to search the Bluetooth name“ B80” to pair, then begin playing music.
Safety Infor mation
Caution:
Please read the following cautions to avoid an unexpected emergency during
using the wireless charger.
- Do not directly touch the device when it is overheated, which may bring scald hurt.
- Do not put the device in the place close to Heater, Microwave, or Electronic Cooker, which may cause the device to overheat and lead to a fire.
- Do not frequently fall or bump the device, which may cause an explosion.
- Do not let children play or use the device when an adult is not present.
- Do not put or use the device in an environment of low temperature or humidity, the normal environment temperature should be 0-50 ℃.
- Do not disassemble or repair the device personally.
- Do not put the magnetic stripe like a bank card close to the device, which may cause the magnetic failure.
- Do not put the device close to medical instruments in the range of 20cm. Which may cause signal interference.
- Please make sure the charged device is off the protective cover before directly charging to the wireless charger.
- Please plug off the adapter when not using the device, which can save the life time and avoid the damage.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (a ) This device may not cause harmful
interference, and (b ) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
The distance between user and products should be no less than 20cm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>