KLARSTEIN 10034846 Gas BBQ grill Instruction Manual

KLARSTEIN 10034846 Gas BBQ grillSAFETY INSTRUCTIONS

• Read the operating instructions before using the appliance and observe the operating and installation instructions.
• Retain this manual for future reference.
• Use outdoors only.
• Accessible parts may be very hot. Never leave children, elderly infi rm persons or pets near the barbecue.
• Children must not use the appliance! Persons with reduced physical, sensory or mental capabilities or those with a lack of experience and knowledge may only use the device if they are instructed on how to do so by a person responsible for their safety, or if they are supervised and understand the hazards associated with the use of the device.
• Do not move the appliance during use.
• Turn off the gas supply at the gas cylinder after use.
• Do not modify the appliance.
• This appliance must be kept away from fl ammable materials during use.
• The regulator and hose must be connected correctly to the appliance. A spanner must be used to tighten the nut onto the connection thread.
• Do not keep any gas cylinder inside the barbecue trolley when using the appliance. It is forbidden to insert / put gas cylinder in to the appliance when in use.

For your safety if you smell gas

• Turn off gas supply at gas cylinder.
• Extinguish all naked fl ames. Do not operate any electrical appliances.
• Ventilate the area.
• Check for leaks as detailed in this manual.
• If odor persists, contact your dealer or gas supplier immediately.

Precautions

1. Leak test all connections after each cylinder refill or before each use.
2. Never check for leaks with a match or open flame.
3. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
4. Any LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.

Special notes

1. If you have any questions concerning assembly or operation, consult your dealer or LPG Gas Company.
2. When in use place the appliance and cylinder on a flat level surface.
3. Never light the grill or rear burners with the hood in the closed position.
4. Never light the side burner with the lid in the closed position.

CONNECTING THE GAS CYLINDER TO THE APPLIANCE

Note: The appliance must be equipped with an EN 16129-approved gas regulator and EN 16436-1-approved gas hose with a minimum length of one metre. If not included in the delivery, they must be purchased additionally.

• Your barbecue can be used with gas cylinders between 11 kg and 15 kg. The maximum size of the gas cylinder should be: Ø 32 cm and the maximum height 60 cm. Follow the technical information as stated in the instruction manual and Check with your local gas supplier to have a suitable gas cylinder for your barbecue.
• A pan with a diameter of Ø 12-22 cm can be placed on the hot plate of the side burner.
• This appliance is only suitable for use with low-pressure butane or propane gas or LPG mixtures, fitted with the appropriate low-pressure regulator via a flexible hose.
• The hose should be secured to the regulator and the appliance with hose clips. Make sure the flexible hose could not come in contact with hot surface and avoid twisting.

Regulator and hose

• Use only regulators and hose approved for LP Gas at the above pressures. The life expectancy of the regulator is estimated as 2 years.
• The use of the wrong regulator or hose is unsafe. Always check that you have the correct items before operating the barbecue.
• The hose used must conform to the relevant standard for the country of use. Worn or damaged hose must be replaced. Ensure that the hose is not obstructed, kinked, or in contact with any part of the barbecue other than at its connection.

For flexible hose

• Avoid twisting the flexible tube when the appliance is in use. The length of flexible hose shall not exceed 1.50 m. In Finland, the length shall not exceed 1.20 m. The hose should certified according to applicable EN Standard and comply with local code.

Storage of the appliance

• Storage of an appliance indoors is only permissible if the cylinder is disconnected and removed from the appliance. When the appliance is not to be used for a period of time it should be stored in its original packaging and stored in a dry dust free environment.

Gas cylinder

• The gas cylinder should not be dropped or handled roughly! If the appliance is not in use, the cylinder must be disconnected. Replace the protective cap on the cylinder after disconnecting the cylinder from the appliance. The gas cylinder must be sited outside the body of the appliance.
• Always connect or replace the cylinder in a well-ventilated area and away from any source of ignition, never in the presence of a flame, spark or heat source.
• Cylinders must be stored outdoors in an upright position and out of the reach of children. The cylinder must never be stored where temperatures can reach over 50 °C. Do not store the cylinder near flames, pilot lights or other sources of ignition. Do not smoke when touching the gas bottle or lighting the appliance.
• This barbecue is designed for use outdoors, away from any flammable materials.
• It is important that there are no overhead obstructions and that there is a minimum distance of 1 m from the side or rear of the appliance.
• The ventilation openings of the appliance must not be obstructed. The barbecue must be used on a level, stable surface. The appliance should be protected from direct draughts and shall be positioned or protected against direct penetration by any trickling water (e. g. rain).
• Make sure that the gas cylinder compartment (if any) is not obstructed, keep it ventilated and clean.
• Parts sealed by the manufacturer or his agent must not be altered by the user.
• No modifications should be made to any part of this barbecue and repairs and maintenance should only be carried out by a qualified service engineer.

Connection to appliance

• Before connection, ensure that there is no debris caught in the head of the gas cylinder, regulator, burner and burner ports. Spiders and insects can nest within and clog the burner/venturi tube at the orifice. A clogged burner can lead to a fire beneath the appliance.
• Clean burner holes with a heavy-duty pipe cleaner.
• Fit the hose to the appliance using a spanner to tighten it onto the connection thread. If the hose is replaced it must be replaced with a hose and regulator assembly that is CE or CSA certified, with 28-30 mbar output. Disconnect the regulator from the cylinder (according to the directions supplied with the regulator) when the barbecue is not in use.
• The barbecue must be used in a well-ventilated area. Do not obstruct the flow of combustion air to the burner when the barbecue is in use. Only use this barbecue outdoors.

CHECKING FOR LEAKS

• Check the gas grill for leaks before each use. Never use an open flame for the leak test, always use a soapy water solution.
• Make 50-80 ml of leak detecting solution by mixing one part washing up liquid with 3 parts water.
• Ensure the control valve is OFF.
• Connect the regulator to the gas cylinder and the ON/OFF valve to the burner. Ensure the connections are secure and then turn ON the gas.
• Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which must be rectified before use. Retest after fixing the fault.
• Turn off the gas at the cylinder after testing. If leakage is detected and cannot be rectified, do not attempt to cure leakage but consult your gas dealer.

OPERATION

CAUTION
Risk of burns! Accessible parts of the appliance may be very hot. Keep young children away from the hot appliance at all times (even while cooling down!). Wear protective gloves (e.g. oven gloves) when handling particularly hot equipment components.

Before fi rst use

Before cooking for the fi rst time, operate the barbecue for about 15 minutes with the lid closed and the gas turned on LOW. This will “heat clean” the internal parts and dissipate odour from the painted fi nish.

Lighting the barbecue

1. Open the hood of the barbecue before attempting to light the burners.
2. Turn all the control knobs clockwise to the OFF position. OFF
3. Connect the regulator to the gas bottle. Turn the gas supply ON at the regulator. Check with the use of soapy water for any gas leakage between the bottle and the regulator and all hose fittings.
4. Push down the front left control knob and keep pressing whilst turning anti-clockwise to the HIGH position (a clicking sound is heard), this will light the left hand burner. Observe if the burner has lit. LOW If not repeat this process.
5. If the burner has not lit after retrying, wait 5 minutes and repeat step 4.
6. Adjust the heat by turning the knob to the HIGH/LOW position.
7. If the burner does not ignite, light the appliance with a match using the lighting hole in the side of the appliance. Consult your gas dealer to rectify the ignition.
8. To light the remaining burners in sequence from left to right, repeat step 4 above. The cross-lighting channel between the burners will light the burner adjacent to it.
9. When use of the appliance is complete, turn the barbecue control knob to the OFF position, turn the cylinder valve or regulator switch to the OFF position and then turn the control knob on the appliance clockwise to the OFF position.

Note: If the burner fails to ignite during step 4, turn the control knob off (clockwise) and also turn the cylinder valve off. Wait fi ve minutes before attempting to relight with ignition sequence.

Lighting the side burner

1. Open the lid of the side burner.
2. Push down the side burner control knob and keep pressing whilst turning anti-clockwise to the HIGH position (a clicking sound is heard). This will light the side burner. Observe if the burner HI has lit. If not repeat this process.
3. If the burner has not lit after retrying, wait 5 minutes and repeat step 2. LOW
4. Adjust the heat by turning the knob to the HIGH/LOW position.
5. If the burner does not ignite, light the appliance with a match using a long match or taper. Consult your gas dealer to rectify the ignition.
6. To turn the side burner off, turn the control knob clockwise to the OFF position. If you wish to turn the complete barbecue OFF, turn the cylinder valve or regulator switch to the OFF position and then turn the control knob on the appliance clockwise to the OFF position.

Note: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off. Wait five minutes before attempting to relight with ignition sequence.

After each use

• “Burning off” the barbecue after every use (for approximately 15 minutes) will keep excessive food residue to a minimum.
• Clean the barbecue after each use. Do not use abrasive or flammable cleaners, as it will damage the parts of the product and may start a fire. Clean in warm soapy water. Only clean once the product has cooled down.

CLEANING AND MAINTENANCE

WARNING
Risk of injury! All cleaning and maintenance should be carried out when the barbecue is cool and with the fuel supply turned OFF at the gas cylinder.

Outside surface

Use a mild detergent or baking soda and hot water solution. Non-abrasive scouring powder can be used on stubborn stains, then rinse with water.

Barbecue lid

If the inside surface of the barbecue lid has the appearance of pealing paint, baked on grease build-up has turned to carbon and is fl aking off. Clean thoroughly with strong hot soapy water solution. Rinse with water and allow to completely dry. Never use oven cleaner!

Interior of barbecue bottom

Remove residue using brush, scraper and/or cleaning pad then wash with a soapy water solution. Rinse with water and allow to dry.

Wooden surfaces

Wash with a soft cloth and hot soapy water solution. Rinse with water. Do not use abrasive cleaners, degreasers or a concentrated barbecue cleaner on wooden parts.

Cooking grid

Use a mild soapy water solution. Non-abrasive scouring power can be used on stubborn stains then rinse with water.

Cleaning the burner assembly

1. Turn the gas OFF at the control knob and disconnect the cylinder.
2. Remove cooking grill and cooking plate.
3. Clean the burner with a soft brush or blow clean with compressed air and wipe with a cloth.
4. Clean any clogged ports with a pipe cleaner or stiff wire (such as an opened paper clip).
5.  Inspect burner for any damage (cracks or holes). If damage is found, replace with a new burner. Reinstall the burner, check to ensure that the Gas valve orifi ces are correctly positioned and secured inside the burner inlet (venturi).

Maintenance

Have your gas barbecue serviced once a year by a qualified technician.

TROUBLESHOOTING

Burners will not light using the ignition system.

| LP gas cylinder is empty.| Replace with full cylinder.

Faulty regulator.

| Have regulator checked or replace.
Obstructions in burner.| Clean burner.
Obstructions in gas jets or gas hose.| Clean jets and gas hose.
Electrode wire loose or disconnected on electrode or ignition unit.| Reconnect wire.
Electrode or wire damaged. Faulty push button igniter.| Replace electrode or wire. Replace igniter.

Burner will not light with a match.

| LP gas cylinder is empty.| Replace with full cylinder.

Faulty regulator.

| Have regulator checked or replace.
Obstructions in burner.| Clean burner.
Obstructions in gas jets or gas hose.| Clean jets and gas hose.

Low flame or flashback (fire in burner tube –

a hissing or roaring noise may be heard).

| LP gas cylinder too small.| Use larger cylinder.
Obstructions in burner.| Clean burner.
Obstructions in gas jets or gas hose.| Clean jets and gas hose.

Windy conditions.

| Use grill in a more sheltered position.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical
and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

MANUFACTURER & IMPORTER (UK)

Manufacturer
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain
Chal-Tec UK Limited Unit 6 Riverside Business Centre Brighton RoadShoreham-by- SeaBN43 6RE
United Kingdom

References

• Klarstein | Discover the Online Shop for Home & Living
• Klarstein | Your home. Your kitchen. Your style.
• Klarstein | Der Online Shop für Haushaltsgeräte und Home & Living

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>