PANDUIT CT-2300 Hand Crimper Tool Varies Instruction Manual
- June 3, 2024
- PANDUIT
Table of Contents
PANDUIT CT-2300 Hand Crimper Tool Varies
- REMOVE SCREW HOLDING UPPER DIE HALF IN TOOL, AND REPLACE IT WITH LONG SCREW SUPPLIED WITH LOCATOR
- PLACE LOCATOR ON SCREW AS SHOWN
- ALIGN EDGE OF POSITIONING BAR WITH TOOL JAW
- SECURE LOCATOR WITH SUPPLIED LOCKING HEX NUT TO TOOL JAW
- POSITION A: INTENDED FOR DISCONNECTS SLIDE LOCATOR AS SHOWN
- POSITION B: INTENDED FOR RINGS/FORKS SLIDE LOCATOR AS SHOWN
- POSITION C: SWING LOCATOR OUT OF WAY SO SPLICES & WIRE JOINTS CAN BE CRIMPED IN TOOL LOCATOR MUST BE IN POSITION SHOWN IN 4A TO BE PIVOTED. DO NOT ATTEMPT TO PIVOT LOCATOR IN POSITION 4B !
- PLACE CONNECTOR IN CRIMP DIE, MATCHING COLOR DOT ON DIE POCKET WITH COLOR OF CONNECTOR INSULATION
- PLACE CONNECTOR AGAINST LOCATOR AND SQUEEZE TRIGGER 1/2 WAY TO MANUALLY HOLD CONNECTOR IN CRIMP DIE.
- DO NOT PUSH CONNECTOR TOO HARD AGAINST LOCATOR. INSERT WIRE INTO CONNECTOR.
- LOCATOR INCLUDES WIRE STOPS FOR PROPER INSERTION OF WIRE INTO CONNECTOR
- DEPRESS TRIGGER COMPLETELY TO ACTIVATE POWERED, CONTROLLED-CYCLE CRIMP
NOTE: LOCATOR COMES FROM FACTORY PROPERLY ASSEMBLED. DO NOT MAKE ANY ADJUSTMENTS TO THE POSITION OF THE SET SCREW
For Instructions in Local Languages and Technical Support
www.panduit.com/resources/install_maintain.asp
E-mail: cs@panduit.com
Fax: 708-444-6993
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>