Spin Master Toys Far East 92308RX2G4 DCR RDC Batmobile Vehicle Instruction Manual

June 4, 2024
Spin Master Toys Far East

Spin Master Toys Far East 92308RX2G4 DCR RDC Batmobile Vehicle Instruction Manual
Spin Master Toys Far East 92308RX2G4 DCR RDC Batmobile
Vehicle

Product overview

Product overview

CONTENTS

  • 1 Batmobile™ RC

  • 1 4” Figure

  • Controller

  • 1 Instruction Guide

INDOOR / OUTDOOR

CAUTION:
HAIR ENTANGLEMENT — Tie back and cover hair and secure loose clothing prior to play.

Not included
6xAAA (LR03)
1.5 V
1,5 V

HOW TO INSTALL BATTERIES

HOW TO INSTALL BATTERIES
HOW TO INSTALL BATTERIES

HOW TO CONNECT THE CONTROLLER

HOW TO CONNECT THE CONTROLLER

DIRECTIONAL CONTROL

DIRECTIONAL CONTROL
DIRECTIONAL CONTROL

HOW TO FIX DRIFTING

HOW TO FIX DRIFTING
HOW TO FIX DRIFTING

HOW TO INSTALL BATTERIES

  1. Open the battery door with a screwdriver. If used batteries are present, remove these batteries from the unit by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
  2. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
  3. Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.

HOW TO CONNECT THE CONTROLLER

  1. Turn on the vehicle and place it on a flat surface.
  2. On the controller, push the throttle lever up to the maximum position (A) and back to minimum position (B) to connect to the vehicle.
  3. You are ready to drive. Use the remote control to drive.

CONTROLLER NOT CONNECTING

If your vehicle does not connect to the controller the first time, turn the vehicle off, remove batteries from the controller, put the batteries back in and repeat the HOW TO CONNECT THE CONTROLLER instructions.

NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

Safety Precautions

  • Keep hands, hair and loose clothing away from the motor/ wheels when
    power switch is turned ON.

  • Remove batteries when not in use.

  • Parental guidance is recommended for the play.

  • Keep your toy in your sight so that you can supervise it all the time.

  • New alkaline batteries are recommended to obtain maximum performance.

  • Users should keep strict accordance with the instruction manual while operating the product.

Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.

CARE AND MAINTENANCE

Always remove batteries from the toy when it is not being used for a long period of time. Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat.
Do not submerge the toy in water. This can damage the electronic assemblies.

BATTERY SAFETY INFORMATION

Requires 6 x 1.5 V AAA (LR03) batteries. Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision.
Replaceable-rechargeable batteries are to be removed from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

Requires 6 x 1.5 V AAA (LR03) batteries (not included). Batteries or battery packs must be removed for recycling and proper disposal. When this product has reached the end of its useful life, it should not be disposed of with other household waste. EU legislation for Electrical and Electronic Equipment and Batteries, requires these to be separately collected so that they can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”.
You can return an old product to your retailer when you buy a similar new one.
For other options, please contact your local council.

FCC STATEMENT:

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:

  • Reorient or relocate the receiving antenna
  • Increase the separation between the toy and the radio or the TV
  • Consult the dealer or an experienced TV-radio technician for help.

NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party please visit fcc.spinmaster.com.

CANADIAN Class B statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Do not change or modify anything on the toy

Keep away from obstacles and electrical hazards.

Spin Master International B.V. hereby declares that the radio equipment type Batmobile™ RC is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:

https://www.spinmaster.com/en-US/legal/regulatory-documents/

CAUTION: Hair Entanglement. Tie back and cover hair and secure loose clothing prior to play.

Before first use: Read the user’s information together with your child.

WARNING: CHOKING HAZARD – Small parts & small ball. Not suitable for children under three years.

Retain this information, addresses and phone numbers for future reference.

Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada

BATMAN and all related characters and elements © & ™ DC

Spin Master logo & © 2022 Spin Master Ltd. All rights reserved.

T92308_0001_20141821_GML_IS_R1
T92308_0002_20139348_GML_IS_R1

Frequency Band(s): 2 420 MHz – 2 465 MHz / Maximum radio frequency power transmitted: < 6.17 dBm.

www.spinmaster.com
customercare@spinmaster.com

Country of Origin – Placement
Factory according to production country to print Country of Origin (COO)
If corresponding country is not in below, contact Spin Master to provide translation

China
MADE IN CHINA

Vietnam
MADE IN VIETNAM

India
MADE IN INDIA

Mexico
MADE IN MEXICO

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals