Spin Master RX2G4 TURBO BOOST BATMOBILE User Manual
- June 5, 2024
- SPIN MASTER
Table of Contents
RX2G4 TURBO BOOST BATMOBILE
User Manual
CONTENTS
CAUTION:
HAIR ENTANGLEMENT —
Tie back and cover hair and secure loose clothing prior to play.
2 x AAA (LR03) 1.5 V
Not included 
HOW TO INSTALL BATTERIES
HOW TO CHARGE
HOW TO CONNECT THE CONTROLLER
HOW TO TURBO BOOST WHEELIE
HOW TO DRIVE/CONDUITE
HOW TO CORRECT WHEEL ALIGNMENT
HOW TO INSTALL BATTERIES
- Open the battery door with a screwdriver. If used batteries are present, remove these batteries from the unit by pulling up one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
- Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
- Replace the battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.
HOW TO CHARGE
- Turn the vehicle OFF.
- Plug the small end of the charging cable into the charging compartment on the vehicle.
- Plug the USB charging cable into a 5V DC computer outlet.
- Charging LED indicates charging. Blinking for charging and ON when fully charged.
HOW TO CONNECT THE CONTROLLER
- Turn on the vehicle and place it on a flat surface.
- Press any button on the controller.
- You are ready to drive. Use the remote control to drive.
CONTROLLER NOT CONNECTING
NOTE: If your vehicle does not connect to the controller the first time,
turn the vehicle off, remove batteries from the remote, put it back in, and
repeat the HOW TO CONNECT THE CONTROLLER instructions.
HOW TO TURBO BOOST WHEELIE
- Turn on the vehicle and begin driving.
- Press the Turbo button, hold it down for a longer boost.
- The Batmobile™ will turbo boost forward.
NOTE: If the normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset the product, turn it completely off, then turn it back on. If the normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.
SAFETY PRECAUTIONS: – Keep hands, hair, and loose clothing away from the motor/ wheels when power switch is turned ON. – Remove batteries when not in use. – Parental guidance is recommended for the play. – Keep your toy in your sight so that you can supervise it all the time. – New alkaline batteries are recommended to obtain maximum performance. – Users should keep strict accordance with the instruction manual while operating the product. Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require the user to reset the toy.
CARE AND MAINTENANCE: Always remove batteries from the toy when it is not
being used for a long period of time.
Wipe the toy gently with a clean damp cloth. Keep the toy away from direct
heat. Do not submerge the toy in water.
This can damage the electronic assemblies.
BATTERY SAFETY INFORMATION: Batteries are small objects. Replacement of
batteries must be done by adults.
Follow the polarity (+/-) diagram in the battery compartment. Promptly remove
dead batteries from the toy. Dispose of used batteries properly. Remove
batteries for prolonged storage. Only batteries of the same or equivalent type
as recommended are to be used. DO NOT incinerate used batteries. DO NOT
dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old
and new batteries or types of batteries (i.e. alkaline/standard/rechargeable).
Using rechargeable batteries is not recommended due to possible reduced
performance. Rechargeable batteries are only to be charged under adult
supervision. Replaceable-rechargeable batteries are to be removed from the toy
before being charged. DO NOT recharge non-rechargeable batteries. DO NOT
short-circuit the supply terminals.
SPECIAL LiFe BATTERY INSTRUCTIONS: Never charge the battery unattended. – Charge the battery in an isolated area. Keep away from flammable materials. – Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or igniting. – Do not disassemble, modify, heat, or short circuit the batteries. Do not place them in fires or leave them in hot places. – Do not drop or be subject to strong impacts. – Do not allow the batteries to get wet. – Only charge the batteries with the specified Spin Master™ battery charger. – Only use the batteries in the device specified by Spin Master™. – Carefully read the instruction guide and use the batteries correctly. – In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. – Batteries must be recycled or disposed of properly.
SPECIAL NOTE TO ADULTS: Regularly examine for damage to the plug, enclosure, and other parts. In the event of any damage, the toy must not be used with the charger until the damage has been repaired.
Spin Master International B.V. hereby declares that the radio equipment type TURBO BOOST BATMOBILE™ is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://doc.spinmaster.com
Frequency Band(s): 2 420 MHz – 2 465 MHz / Maximum radio frequency power transmitted: < 10dBm
Keep away from obstacles and electrical hazards.
This toy is only to be connected to equipment bearing either of the following symbols:
or
Do not change or modify anything on the toy.
Production Notes
Artwork serial (docket) :
T92307_0002_20132314_GML_IS_R4.vp.el (DCR_Batmobile_Turbo_Boost_S22)
Visual Branding Designer / Date:
Cary Wang (07-14-2021)
- This contract proof is simulated ISO-G7 printing on CCNB.
- CMYK color on printing must closely match to this sheet.
- Pantone color most closely matches to Pantone book.
- Print sample standard viewing condition is 5000°K light booth.
- Screen ruling 175 LPI or above.
- Die-line may be slightly different from the latest development, check with the product vendor or Spin Master.
- Die-line, placement line, and placement indicator do not print.
CONFIDENTIAL / UNAUTHORIZED USE PROHIBIT
Country of Origin – Placement
Factory according to production country to print Country of Origin (COO)
If the corresponding country is not below, contact Spin Master to provide a
translation
MADE IN CHINA
Before first use: Read the user’s information together with your child.
Retain this information, addresses, and phone numbers for future reference.
NORTH AMERICA
1-800-622-8339,
customercare@spinmaster.com
UK – 0800 206 1191, serviceuk@spinmaster.com
CAUTION: Hair Entanglement. Tie back and cover hair and secure loose clothing prior to play.
Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221
Spin Master International B.V., Kingsfordweg 151, 1043 GR Amsterdam, NL
Spin Master Australia Pty Ltd, Suite 101, Level 1, 18-24 Chandos Street, St
Leonards, NSW 2065; 1800 316 982
Spin Master Toys UK Ltd. Boston House, Boston Drive, Bourne End,
Buckinghamshire, SL8 5YS, UK
Тел.: 8 800 301 38 22
MADE IN CHINA
WARNING : CHOKING HAZARD-Small parts. Not suitable for children under three years.
THE BATMAN and all related characters and elements & ™ DC Comics and Warner Bros. Entertainment Inc.
Spin Master logo & © Spin Master Ltd. All rights reserved. Spin Master Ltd. reserves the right to discontinue the www.AIRHOGS.com/BATMANRC website at any time.
T92307_0002_20132314_GML_IS_R4
T92307_0003_20137293_GML_IS_R4
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>