Spin Master 66812RX2G4 Monster Jam Grave Digger Trax Instruction Manual
- May 15, 2024
- SPIN MASTER
Table of Contents
Spin Master 66812RX2G4 Monster Jam Grave Digger Trax
Product Information
Specifications:
- Model: Monster Jam Grave DiggerTM TraxTM
- Compliance: CAN ICES-3(B)/NMB-3(B), Directive 2014/53/EU
- Frequency Band(s): 2.420-2.465GHz
- Maximum Radio Frequency Power
Product Usage Instructions
Befoe First Use:
- Read the user’s information provided with the product together with your child.
- Keep the product numbers for future reference in case you need to contact support.
Important Notes:
- Do not change or modify any parts of the toy.
- Follow all safety guidelines and recommendations provided in the user manual.
Usage Steps:
- Ensure the toy is fully charged or has fresh batteries inserted.
- Turn on the toy using the designated power button.
- Follow the controller instructions to operate the Monster Jam Grave DiggerTM TraxTM.
- Use the toy in a suitable indoor or outdoor environment as per the product specifications.
FAQ
Q: How do I charge the Monster Jam Grave DiggerTM TraxTM?
A: To charge the toy, use the provided charging cable and connect it to a suitable power source following the instructions in the manual.
Q: What should I do if the toy malfunctions?
A: If you encounter any issues or malfunctions, refer to the troubleshooting section of the user manual or contact customer support for assistance.
POWER BUTTON
For in-depth video instructions go to MONSTERJAMRC.COM
INDOOR / OUTDOOR
CONTENTS
CAUTION:
HAIR ENTANGLEMENT — Tie back and cover hair and secure loose clothing prior to
play.
HOW TO INSTALL BATTERIES
- Press down on release button (A) to slide down battery cover (B).
- Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
- Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.
HOW TO CHARGE
- Turn the vehicle off.
- Plug the small end of the charging cable into the charging port.
- Plug the charging cable into a 5V DC computer outlet.
- Pulsing ON/OFF LED indicates battery is charging, solid ON for fully charged.
HOW TO CONNECT THE CONTROLLER
- Turn on the vehicle and place it on a flat surface.
- Hold the controller near your vehicle, press the power button and wait until the power light stops flashing.
- You are ready to drive. Use the remote control to drive.
DRIVING ON WATER
DO NOT USE REMOTE IN WATER.
NOTE: Before driving on water
ENSURE THE CHARGING PORT IS FIRMLY COVERED.
There is no additional preparation required to drive on water. Fully
submerging the vehicle in water is not recommended.
DIRECTIONAL CONTROL
HOW TO CORRECT WHEEL ALIGNMENT
TROUBLESHOOTING
CONTROLLER NOT CONNECTING
If your vehicle does not connect to the controller the first time, turn the
vehicle off, remove batteries from the controller, put the batteries back in
and repeat the HOW TO CONNECT THE
CONTROLLER instructions.
OUT OF RANGE / LOW BATTERY
- Controller will beep when you are close to driving out of range.
- Drive vehicle toward you until beeping stops.
- If beeping continues, this indicates low battery.
- Return and immediately fully charge the vehicle.
- NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.
- Safety Precautions: – Keep hands, hair and loose clothing away from the motor/ wheels when power switch is turned ON. – Remove batteries when not in use. – Parental guidance is recommended for the play. – Keep your toy in your sight so that you can supervise it all the time. -New alkaline batteries are recommended to obtain maximum performance. – Users should keep strict accordance with the instruction manual while operating the product.
- Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.
- CARE AND MAINTENANCE: Always remove batteries from the toy when it is not being used for a long period of time. Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat. Do not submerge the toy in water. This can damage the electronic assemblies.
- SPECIAL NOTE TO ADULTS: Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the charger until the damage has been repaired. This toy is not intended for children under 3 years old. This toy must only be used with the recommended charger.
- BATTERY SAFETY INFORMATION: Requires LiFePO4 6.4V/700mAh battery (included) and 2 x 1.5 V AAA (LR03) batteries (not included). Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable-rechargeable batteries are to be removed from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
- SPECIAL LiFePO4 BATTERY INSTRUCTIONS: Never charge battery unattended. – Charge battery in an isolated area. Keep away from flammable materials. – Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or igniting. – Do not disassemble, modify, heat, or short circuit the batteries. Do not place them in fires or leave them in hot places. – Do not drop or subject to strong impacts. – Do not allow the batteries to get wet. – Only charge the batteries with the specified Spin Master™ battery charger. – Only use the batteries in the device specified by Spin Master™. – Carefully read the instruction guide and use the batteries correctly. – In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. – Batteries must be recycled or disposed of properly.
- PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed and non-replaceable. Product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or deform product during disassembly. Ensure product is turned off, then use a screw driver to remove all screws. Separate product body halves to expose internal electronics. When battery is visible in its entirety use scissors to cut a single battery wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated, and the battery is free from the rest of the product. Dispose of battery in accordance with your local battery recycling or disposal laws.
- Contains 1 LiFePO4 6.4V/700mAh battery (included) and requires 2 x 1.5 V AAA (LR03) batteries (not included). Batteries or battery packs must be removed for recycling and proper disposal. When this product has reached the end of its useful life, it should not be disposed of with other household waste. EU legislation for Electrical and Electronic Equipment and Batteries, requires these to be separately collected so that they can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.
LED INDICATORS
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communication. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:
- Reorient or relocate the receiving antenna
- Increase the separation between the toy and the radio or the TV
- Consult the dealer or an experienced TV-radio technician for help.
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party please visit fcc.spinmaster.com.
Spin Master International B.V. hereby declares that the radio equipment type Monster Jam Grave Digger™ Trax™ is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://doc.spinmaster.com
- Do not change or modify anything on the toy.
- Keep away from obstacles and electrical hazards.
- BEFORE FIRST USE: Read the user’s information together with your child.
- Retain this information, addresses and phone numbers for future reference.
- Spin Master Ltd. reserves the right to discontinue the MonsterJamRC.com website at any time.
WARNING: CHOKING HAZARD – Small parts. Not suitable for children under three years.
Spin Master logo & © 2022 Spin Master Ltd. All rights reserved. ©2023 Feld Motor Sports, Inc. MONSTER JAM™, UNITED STATES HOT ROD ASSOCIATION™, USHRA™, GRAVE DIGGER™, are trademarks used under license from Feld Motor Sports, Inc. All rights reserved.
Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada
MADE IN CHINA
Juguete Importado por: Spin Master México, S.A. de C.V., Av. Insurgentes Sur
No.1070 piso 8, Colonia Insurgentes San Borja,
Alcaldía Benito Juárez. C.P. 03100,
Ciudad de México. R.F.C. SMM050627V48 Atención al cliente: 800 9530147
WWW.SPINMASTER.COM
customercare@spinmaster.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>