DURGOD GK68 RGB Aluminum Mechanical Keyboard User Manual
- June 5, 2024
- DURGOD
Table of Contents
GK68
User Manual
System Requirement
2.4G Mode: Windows XP/ Vista / Win7 / Win8 /Win10 / Mac Bluetooth 5.0 Mode: Win8/Win10 Usb Port: Free USB (1.1/2.0/3.0) port
Installation steps
- Take out the keyboard and insert the USB receiver into the USB interface of the computer.
- Take out the attached battery and install it into the battery slot on the back of the keyboard
- Restart the computer, the system will automatically install the driver
- Wait for the computer to tell you that the new hardware is installed
- Use your keyboard at this point
Note: It is recommended to connect the motherboard USB2.0 interface.
Warm Prompt
- Do not pour any liquid into the keyboard, otherwise, it will damage the keyboard
- Clean the keyboard regularly to avoid accumulating too much dust and affecting the feel
Disclaimer
The information contained in this manual has been strived to be correct and
complete, if any errors or omissions are not subject to any liability and the
right is reserved to change this brochure at any time References to hardware
and software without prior notice
Smart power saving mode
The keyboard will automatically enter after no key action for more than 30
minutes in 2.4G and Bluetooth mode, Sleep state, press any key to wake up the
keyboard during normal use.
Power switch
The power switch of this keyboard is in the back position. To turn ON the
power switch of the keyboard, the switch should be moved to the ON position
2.4G wireless connection mode
Use 2.4G wireless connection mode, need to switch to 2.4G mode by using key
combination after boot. And check whether the USB wireless receiver that comes
with the unit has been plugged into the computer’s USB interface. Plug in a
USB receiver and use 2.4G wireless connection mode. The keyboard works in 2.4G
mode at factory Paired, no need to pair, if you want to pair, long-press FN+Q
for more than 5 seconds, however Then insert the 2.4G receiver and the match
is completed.
Switch to 2.4G mode (green light prompt)
F function key combination
Other key combination functions
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SHENZHEN ARBITER TECHNOLOGY CO..LTD
add. blag A, Meissheng Industrial park, Chongqing Rd.,
FUyong, bao a District, Shenzhen, China 518103
E-mail: arbiter@myarbiter.cn
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>