KEYSION KSFWCP01 Walnut Single Coil Fast Wireless Charger User Manual

: June 5, 2024
: KEYSION

Table of Contents

Product Introduction
Product appearance
Instructions For Use
Applicable Devices
What’s In The Box
FCC Warning
Read User Manual Online (PDF format)
Download This Manual (PDF format)

WALNUT SINGLE-COIL FAST
WIRELESS CHARGER
User Manual

Product Introduction

WALNUT FAST WIRELESS CHARGER uses a walnut CNC shell, natural wood texture, and texture, plus a simple and elegant appearance design, and supports up to Qi EPP 15W fast wireless charging experience. It is fully compatible with Qi- standard mobile digital devices, and can achieve a wireless charging experience of “discharging and charging”.

Product Parameter

Product appearance

LED Status Prompt

Instructions For Use

Connect the USB port of the charging cable to the power adapter.
Connect the Type C interface of the USB charging cable to the wireless charger. After the power is turned on, the wireless charger indicator will flash 3 times.
Place the device to be charged that supports wireless charging on the wireless charger and charge it immediately. When the device starts to charge, the charging indicator will remain a green breathing light or a blue breathing light depending on the charging power. (The indicator light will automatically turn off when the device that automatically emits a saturated signal is full. Not all devices will automatically turn off when they are full)
When using fast wireless charging equipment, you need to use Qualcomm standard QC2.0/QC3.0 fast charging source adapter.

Applicable Devices

Digital devices that comply with the Qi standard can be compatible. More device models can be checked on the Qi official website.

What’s In The Box

Walnut single-coil fast wireless charger
USB charging cable
User manual

Attentions

Please keep the product away from water and other liquids.
Please use this product at an ambient temperature of 0-45.
Do not severely impact, disassemble, repair, or modify this product by yourself.
Do not touch corrosive chemicals such as benzene and thinners.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance between 20cm from the radiator and your body.