KEYSION 240505 Wood bracket wireless charging User Manual

: June 4, 2024
: KEYSION

Table of Contents

KEYSION 240505 Wood bracket wireless charging
Product parameters:
How to：
RF Exposure Warning Statements:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KEYSION 240505 Wood bracket wireless charging

Thank you for using this product Please read this manual carefully before use to ensure safe and correct use

Product parameters:

Enter: DC5V/2A|DC9V/1.67A
OutputDC9V/1A,7.5V/1A,5V/ 1A
Frequency Range: 110-205kHz
Wireless Power:Max 10W

How to：

cross-stitch the ones and twos in the picture;
Connect the MICROUSB cable to the MICROUSB port on the wireless charger and connect the other end of the cable to the USB port or the USBAC adapter (which uses the QC3.0 or PD protocol adapter), with a red light indicating that the charger is properly connected and ready to use;
Place the device on a wireless charger and make sure it is in a central position;
When it is properly charged, the charger indicator lights up blue; Points to note:
Keep the charger away from water or other liquids.
If you need to clean the charger; make sure it is not connected to the power supply.
The ambient temperature for use is approximately 0-40oC.
If your phone has a protective case, you may need to remove it to successfully connect when using a wireless charger.
When a non-rechargeable device is placed on the wireless charger; the FDO protection function is triggered, and the indicator light flickers, unable to work properly.
When the charging temperature is higher than 60 ° C, the NTC protection function is triggered, and the indicator lamp flickers andean not work normally.

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Warning Statements:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.