KOAMTAC KDC185 Charging Cradle Mini User Guide
- June 5, 2024
- KOAMTAC
Table of Contents
KOAMTAC KDC185 Charging Cradle Mini
What’s in the Box
- 1x KDC185 2-Slot Cradle
- 2x No-Boot Spacers (mounted on the Cradle)
- 2x Ring Trigger Spacers (Optional)
- 2x Ring Trigger No-Boot Spacers (Optional)
- 1x USB Type-C Cable
- 1 x USB Wall Adaptor
- 1x KDC185 10-Slot Cradle
- 10 x No-Boot Spacers (mounted on the cradle)
- 10 x Ring Trigger Spacers (Optional)
- 10 x Ring Trigger No-Boot Spacers (Optional)
- 1x 12V/10A DC Power Adaptor
Cradle Power LED Status
Green: Always on when the cradle is powered
Additional Accessories
- KDC185 Safety Glove
- KDC185 Ring Trigger
- Protective Rubber Boot
- USB Type-C Cable
Charging via Type-C Port (2-Slot)
Connect the USB wall adaptor and the USB cable, then connect the cable to the
USB Type-C port on the back of the charging cradle. (A)
Battery LED Status
Charging via DC Connector (10-Slot)
Connect the Power Adaptor to the DC Jack on the back of the 10 Slot cradle.
(B)
Charging without a Protective Boot
Make sure the No-Boot Spacer is installed on the cradle. Insert the KDC185
into the cradle with the device mounting direction as shown below (C)
Charging with a Protective Boot
- Remove the No-Boot spacer from the cradle by pulling up tabs on the front and rear of each spacer. (D)
- Insert the KDC185 with a Protective Boot into the cradle with the device mounting direction as shown below. (E)
Charging Ring Trigger and Protective Boot
- Flip the Ring Trigger Spacer upside down and locate the pogo contacts. Next, flip the Ring Trigger Spacer back over and insert it into the cradle making sure the pogo contacts on the Spacer make contact with the pogo pins on the cradle. (F)
- 2. Insert the Ring Trigger Spacer into the cradle in the orientation shown below. (G)
- KDC185 Ring Trigger can now be charged while wearing a protective boot. Charge the device by placing the device on the cradle with the scan engine facing upward. (H)
Charging Ring Trigger without Protective Boot
Attach the Ring Trigger No-Boot Spacer to the cradle. Insert the KDC185 Ring
Trigger without Protective Boot into the cradle with the scan engine facing
upward. (I)
Ring Trigger No-Boot Spacer Removal
Remove the Ring Trigger No-Boot Spacer from the cradle by pulling the tab on
the front of the spacer up. (J)
Ring Trigger Spacer Removal
Hold the grooves on both sides of the spacer and pull them up to remove the
Ring Trigger Spacer from the cradle. (K)
500mAh Battery Charging
Place the battery on the cradle by aligning the directior of the battery with
the shape of the battery slot. (L)
116 Village Blvd, Ste 305, Princeton, NJ 08540 +1 609-256-4700 p|+1 609-228-4373f info@koamtac.com| www.koamtac.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>