Dongguan LOVE-14-TX Transmitter User Manual
- June 5, 2024
- Dongguan
Table of Contents
Dongguan LOVE-14-TX Transmitter
User Manual
LOVE-14-TX Transmitter
- Press and hold the power button of the receiver for 2 seconds, the LED white light will be on;
- Then turn on the transmitter, the product directly enters the speed 1 to work;
- Then press the button on the transmitter to switch the function mode cycle,
- Press and hold the transmitter button for 2 seconds to pause the receiver motor;
LOVE-2020-14-RX Receiver
- Press and hold the power button of the receiver for 3 seconds, the LED white light is on, the motor does not move, and it enters the standby state;
- Then short press the button on the machine or press the remote control to switch the function mode, all motor modes are speed 1–speed 2–speed 3– Pulse 4-pulse 5-pulse 6-speed 1…, mode cycle, the receiver LED light flashes synchronously with the function frequency
- Press and hold the power button of the receiver for 3 seconds, the product will be turned off, and the white LED light will be off; or long press the button of the transmitter for 2 seconds to turn off the receiver; · After the receiver is turned on, if there is no operation for 15 minutes, it will automatically shut down;
- The light flashes when charging and stays on when fully charged
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>