seenDa IWG-DHXKB01 Wired Backlit Keyboard User Manual
- June 5, 2024
- SeenDa
Table of Contents
seenDa IWG-DHXKB01 Wired Backlit Keyboard
Specification
- Dimension 44.5 10 4.5 CM
- Weight 690 g
- Length of the wire 1.5M
- Compatible Operating System Win XP / Win 7/ Win 8 / Win 10
Instructions of multimedia keys
For using multimedia functions, you need to press and hold the button “FN” first, and then press the corresponding function button.
Press F1-F12 keys directly, you can only use the functions of F1-F12.
Instruction of Multimedia Key Function
Instruction of Backlight
-
Press the button , then you can switch on / off the backlight of the keyboard.
-
Press and hold the button first, and then press the
button ， you can switch on / off the breathing light mode of the backlight. -
Press and hold the button first, and then press the button you can adjust the brightness of the backlight.
Instruction of typing Special symbol
For typing these Special symbols, you need to press and hold the button first, and then press the corresponding function button
FCC Statment
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction