SeenDa SM012 Wireless 2.4G Noiseless Mouse User Manual
- June 5, 2024
- SeenDa
Table of Contents
SeenDa SM012 Wireless 2.4G Noiseless Mouse
Installation
Data parameter
Basic:
- Data transmission: 1 Mbps
- Frequency: 2403.8SMHZ-2479.85MHz
- Channel: 16
- Engine: Optical
- Distance: 3Qm
- Voltage : 1.SV
- Current: llmA
- Mouse Key life : Above 3 millions
- Mouse Size: 99x60x38.2mm
- MouseWelght: SOg
Step current:
- Working current = 11 mA
- Standby current= 1.3mA
- Dormancy current= SOuA
- No receiver state = 10-2SuA
- Tracking performance: Mouse Resolution: 1600DPI
- Mouse Rate of return : 250Hz
System requirement
- IBM or compatible computer
- Windows: 20001 ME/ XP(x64) / Vista /7 / 8 /10
- MacOSX(More thanV10.4) Workable USB port
Package contents
- Wirless mouse
- Nano receiver
- Quick start guide
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.