Guangdong Jianjian Intelligent Technology 2021JJRC3 GPS Drone User Manual

Guangdong Jianjian Intelligent Technology 2021JJRC3 GPS Drone

INTRODUCTION

Thank you for purchasing our GPS Drone. Please read all instructions and warnings carefully before operating Please also keep this instruction manual tfor future referenca and maintenance.

WARNING :

• When taking off make sure that the operator is 3 meters away from the drone, and keep far away from any crowds and property.
• The players must operate the drone as required by the instructions. Pay attention to the flight safety and understand the accident liability caused by your own negligence!
• When outdoor before taking off please confirm that the GPS calibration is completed and the PS signal number is more then 10N/S.
• This drone provides two flight modes: indoor mode and GPS mode, before flying. please select the appropriate mode according to the environment.
• Please read this manual carefully before operation and keep it properly for future reference

IMPORTANT INSTRUCTION

• This product is not a toy. It is a precision device, integrating machinery and electronics with air mechanics and high frequency transmission. It requires correct assembly and debugging to avoid any accident. The user should operate and control this product in a safe manner. In case of incorect operation, it may cause serious injury or damage property. It can also be lost due to incorrect operation.
• This product is suitable for those who are experiencing operating UAV and age no ess than 14 years
• In the event of a problem dunng using. operating, or maintenance, please contact the local sales agent or retailer or keep in touch with the responsible staff of our company
•  Small parts are included with this product. Please place it beyond the reach of the children to avoid a CHOKING HAZARD or parts being mistakenly swallowed.

INTRODUCTION SAFETY PRECAUTIONS

• This R/C lying model can be dangerous when in use, please make sure you keep it far away from any person or spectators when flying.
• Incorrect installation, poor conditions, or uses not familiar with operation may cause damage to the aircraft or injure people or may cause an unexpected accident.
• Please pay close attention to flying safety and learn to recognize more dangerous conditions which may cause an accident due to your own negligence Keep it far away from any structures or crowds
• This R/C aircraft may vary slightly in speed or sensitivity while flying and can cause potential danger.
• Therefore, please keep it far away from crowds, buildings, trees, structures, high voltage wire, etc.
• Please also avoid fiying in adverse weather conditions such as rain, electrical storms, and high winds to ensure satety of the user, any spectators, and surrounding property
• Keep it away from any moist environment
• The inside of the aircraft is composed of many precision electronic and mechanical parts.
• Therefore.please try to avoid any moisture or water content from entering the main body of the aircraft as it may cause a breakdown of the mechanical and electronic parts and thus cause an accident.
• Only operate with included parts for intended use Please use the oniginal parts for any re-equipping or maintenance to ensure flying safety,
• Please operate and use only under the scope of the product function permitted. Using unapproved parts will void warranty.
• DO NOT use for any illegal purpose or use beyond the scope of which your local laws and regulations have stipulated.
• Avoid Controlling it independently New users may have certain difficulties during the early stages of learning to operate this aircraft
• Please try to avoid operating the aircraft alone. When available, always operate this aircraft under the guidance otf a more experienced user
• Do not operate under the influence of drugs or alcohol Please operate this RIC aircraft according to your own state and flying skills.
• Any fatigue, bad mental state, or incomect operation may increase the probability of accidental risk.
• Please keep a safe distance from aircraft when using top speed When the drone is flying.please keep the drone far from the operator and any Surrounding persons or objects so as not to cause danger or damage
• Store it in a cool,dry place The R/C aircraft is composed of material such as metal, riber, plastic, electronics etc.
• Therefore, please keep it away from any heat source and avoid prolonged exposure to direct sunlight Excessive heat exposure can cause distortion and damage

Know Your Drone

1.  Drone top cover
2.  Drone bottom cover
3.  Propeller
4.  Arms
5.  Motor
6.  Lithium battery
7. Legs
8.  Bottom camera
9.  Main camera/Gimbal cover
10.  Switch (Depress 3 seconds take on/off
11. Memory card slot

ACCESSORIES

KNOW YOUR REMOTE CONTROL

1.  Surround flight GPS on-off (depress 3 seconds)
2.  Left joystick/3 Speeds mode (Press down)
3.  Headless mode (depress 3 seconds) Return To Home
4.  Start (unlock)
5.  Anternna
6.  Compass
7.  LCD display
8.  Right joystick
9.  One key ascend descend (depress 3 seconds)
10.  Photo/Video (depress 3 seconds)
11.  Power switch (depress 3 seconds)
12.  Holder for phone
13.  Camera upward
14.  Camera downward

LCD DISPLAY

LITHIUM BATTERY INSTRUCTION

Remote control battery installation Open the battery cover and insert the 3 AA batteries correctly according to the electrode instructions (Batteries not included)

Note

•  When the remote control is in low power, there is a DIDIDI sound. You need to change the battery.
• Meanwhile, the LCD screen TX indicates the voltage is less than 3.5V. (Depending on the environment, the value will vary)
•  Make sure the battery is loaded corectly according to the polarity indications on the battery compartment
•  Please do not mix old and new batteries together
•  Please do not mix different types of batteries together

Battery charging for drone

1.  Depress the clip at the bottom of the batteryy box
2.  Take out battery.
3.  Connect lithium battery and USB charging interface by USB charger

BATTERY INSTRUCTIONS

• There is a certain risk when using a lithium battery. It may cause fire, body injury or property loss. Users must be aware of the risks and take full responsibility for using batteries improperly
• If battery leakage occurs, please avoid contacting your eyes and skin with electrolytes Once it happens, please wash your eyes with clean water and seek medical care immediately
• Please remove the plug immediately if you sense any peculiar smell, noise or smog Battery charging
• Please use the charger from the original factory to ensure your safe usage
• Do not charge dilatant or outworn battery
• Do not overcharge the battery. Please unplug the charger once fully charged
• Do not charge the battery next to in flammables, such as carpet, timber floor or wood furniture or on the surface of electro-conductive objects Please always keep an eye on the battery when charging.
• Do not charge the battery which has not cooled down yet
• The charging temperature should be between 0 Cto 40 G Rechargeable batteries are to be removed from the product before being Charged.
• Exhausted batteries are to be removed from the product Supply terminals are not to be short-circuited
• The battery chargers used with the toy are to be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage they must not be used until the damage has been repaired
• Non-rechargeable batteries for remote control are not recharged

Battery recycling

Do not dispose the battery as daily rubbish. Please familiarize yourself with the local garbage disposal method and dispose it according to the special requirement

PRE-FLIGHT PREPARATION

• Unfold the drone

  • Unfold the front two arms first (Near thecamera) then extend the back two arms. When making folding. fold the back ams first, then the front.

• Propellers installation
  

• Open the cover of gimbal (for drone with gimbal) Press the clip of the gimbal cover and remove it.

•  The method to assemble clip on phone

•  Install APP software and APP operation refer to WIFI INSTRUCTION

•  Pairing controller and drone Place the drone on a level surface, depress the switch for 3 seconds and switch on it the LED lights flash

• Then switch on the between controller and drone is successful automatically

• The drone defaults to the GPS mode. In this mode, the LCD screen shows “GPs On”

• lf indoor mode is selected, after pairing between controller and drone, the drone’s front lights will turn solid and the back will keep flashing troller, the front lights on the dione tum to solid, the pairing

Compass (magnetometer) calibration
After Pairing, you need to do compass calibration in two steps, press the compass key, and the drone lights begin to flash quickly

• Keep the drone level and pick it up about 1M in height. then rotate 3 circles, there is a DI sound and the back lights on the drone will tum to solid.
• From the bottom, hold the drone face-up about 1M height and rotate it 3 circles there is a Di sound and the front lights also turn to solid, compass calibration is okay

Gyro calibration
Gyro calibration could be applied to ensure the drone flies vertically: Push the two joysticks to the right corner at the same time. When there are sounds of Dl on the controller and the lights on the drone quickly fish, then gyro calibration was successful. The drone must be placed on a level surface and remain stationary while calibrating.

GPS calibration ( Satellite searching)
After Compass calibration, set the drone back down to level surtace, back lights start flashing. the drone is finalizing its GPS calibration. Once the controller makes a long DI sound and all lights have switched to solid (the GPS signal number is more than 10N/S.). after waiting for 2 minutes, the drone is ready to fly. LCD screen displays GPS ON and “MODE 2

Note

1. In GPS mode, the drone can not be started ina weak GPS signal environment or the GPS calibration is not finished.
2. After succeeding GPS calibration, wait for 2 minutes to take off, the RETURN TO HOME will be more accurate

MODE SWITCHING

• The drone provides twa flight modes: indoor mode (LCD screen shows GPS off and mode 1) and GPS mode (LCD screen shows GPS on and mode 2). Before take-off, the corresponding flight mode can be selected according to the flight environment.
• The drone defaults to the GPS mode In this mode, the drone can be operated only after the satellite searching (GPS calibration) is completed
• Under an indoor and weak GPS signal environment, press the key indoor mode to control the drone.
• In the indoor mode, the drone’s front lights will turn to solid and the back will keep flashing The drone will not provide GPS functions.
• Flight mode can only be selected before take-off. After taking off, it cannot be switched

FLY SAFE

Avoid flying over or near obstacles, crowds, high over-voltage power lines, Trees, airports or bodies of water. Do not fly near strong electromagnetic sources, such as power lines and base stations, as it may affect the onboard compass.

Do not use the drone in adverse weather conditions, such as rain, snow, fog and wind speeds exceeding 10 m/s or 22/mph.

START YOUR FLIGHT

Note:

1. Only can choose a remote controller or mobile phone APP to operate the drone!
2. The drone is NOT equipped with obstacle avoidance, so to fly at GPS mode. please choose an open and wide space for the flight!

Take off and landing
Take off. After compass calibration and GPS calibration, press the key “start” to unlock the drone and push forward the left joystick to realize drone take- off, or just press one key ascend to fly
Landing: Pull down left joystick to realize drone descending or depress 3 seconds one key descent to land the drone

Basic flight
The left joystick controls the flying altitude and direction change and the right joystick is to control the direction of flight.

Left Joystick

Right Joystick

Set 3 speeds mode
Press down 3-speed mode button (Left joystick) you can hear corresponding sounds the drone is set 3-speed mode
Headless mode
Depress 3 seconds the “Headless mode” key, the controller makes sounds DIDI and the back lights on the drone start to flash, the drone is now in headless mode, this will lock the drone flying direction, which means no matter which direction the drone will fly, it always remembers the first set direction. Pressing headless mode” for 3 seconds again, exit this mode
Return to home (RTH)
The Return to Home (RTH) function brings the drone back to the last recorded home point. There are 3 types of RTH at GPS mode: Smart RTH/Low-battery RTH/ Failsafe RTH

Smart RTH
Press the key Return to home, there is a DI sound on
the controller, and the lights on the drone start to flash.
the drone will return to the TAKE OFF point. Press
this Key again, and exit this mode.
Low-battery RTH

• Low-battery RTH is triggered when the drone battery level is low, The drone will fily back to where you are about 20 m away. You can still control your drone. Pull the joystick down to land the drone in a safe area.
• When the drone is under Low Voltage, the controller will make a long “DIDI sound, and all the Indicator lights on the drone will flash. LCD screen RX indicates the voltage is less than 3 6v. (Depending on the environment, the value will vary)

Failsafe RTH
Drone will enter failsafe RTH mode if the signal of the controller is lost, dron file back
to the record point. Rebind the controller to the drone if a drone flies into your view
Pul the joystick down to land the drone in a safe area.
GPS surround flight

• At GPS mode press the surrOund fight key (pic 1), and the drone looks for its direction automatically
• Push the right joystick left front, and the drone flies surround counterclockwise (pic. 2)
• Push the night joystick right front, the drone flies surrounding clockwIse. (pic,3)

Follow me
Follow me function to refer to WIFI INSTRUCTION
Waypoint flight
Way point flight function refers to WIFI INSTRUCTION.
Photo/video taking

• Press the Photo key on the controller to take a photo
• Depress 3 seconds Video” key on the controller to start video taking and depress again to finish
• Players can view photos and videos on APP.

PROBLEM & SOLUTION

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>