CROWNFUL EP1069T-uL Ice Maker Countertop Machine Instruction Manual
- June 5, 2024
- Crownful
Table of Contents
ICE MAKER
INSTRUCTION MANUAL
Model : EP I 069T-UL
Email: support@crownful.com
Read this manual thoroughly before using it and save it for future reference.
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, explosion, electric shock, or injury when using your ice maker, follow these important safety instructions:
- Before using check that the voltage power corresponds to the one shown on the appliance nameplate.
- Do not remove any safety, warning, or product information labels from your ice maker.
- Plug the ice maker into an exclusive grounded 3-prong outlet. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the receptacle.
- This appliance must be grounded. It is equipped with a 3-wire cord having a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
- Avoid the use of an extension cord because it may overheat and cause a risk of fire. However, if it is necessary to use an extension cord:
- Use only 3-wire extension cords with a 3-blade grounding plug.
- The marked rating of an extension cord must be equal to or greater than the rating of this appliance.
- It should be positioned such that it does not drape over the counter or tabletop where it can be pulled on by children intentionally.
- Do not operate any appliance with a damaged cord or plug or after the appliance malfunction or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or adjustment.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
- Do not let cord hang over edge of table or counter.
- Do not place on or near a hot gas or electric burner, or in a heated oven.
- Place the power cord in such a way it cannot be pulled on by children or cause a tripping hazard.
- Place the power cord in such a way that it is not in contact with hot surfaces.
- The use of attachments not recommended or sold by the manufacturer may cause fire, electric shock or injury.
- Do not touch the evaporator when using the ice maker or making ice to avoid suffering from frostbite.
- Do not immerse any part of the product in water.
- To disconnect, turn any control to “OFF”, then remove plug from wall outlet.
- Do not plug or unplug the product with wet hands.
- Unplug the product before cleaning, maintaining and when not in use.
- Do not use with water that is microbiologically unsafe or of unknown quality.
- Do not clean your ice maker with any flammable fluids. The fumes may create a fire hazard or explosion.
- Do not overturn the ice maker. If the ice maker is overturned accidentally, make it stand steadily for 2 hours before powering it on again.
- If the ice maker is brought in from outside in the wintertime, do not use for a few hours, allowing the unit to warm up to the room temperature before operating.
- Never put flammable, explosive, and corrosive articles into the ice maker.
- Never use the ice maker when there is flammable gas leakage.
- Never store or use gas and other flammable articles near the ice maker to avoid any fire.
- Unplug the ice maker before moving it to avoid damaging the refrigerating system.
- Do not attempt to disassemble, repair, modify, or replace any part of your product.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliances by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Close supervision is necessary when any appliance is used by or near children.
- Do not leave the appliance unattended while in use.
- Do not use outdoors.
- Do not use the appliance for other than intended use.
- Please abandon the ice maker according to local regulators as it uses flammable blowing gas and refrigerant.
- Please refer to local regulations regarding the disposal of the appliance for its flammable refrigerant and blowing gas.
SAVE THESE INSTRUCTIONS FOR HOUSEHOLD USE ONLY
KNOW YOUR ICE MAKER
1. Top lid
2. Evaporator
3. Air outlet
4. Viewing window
5. Ice tray
6. Ice shovel
7.Ice basket| 8. Ice scoop
9. Control panel
10.” MAX” water level
11. Water reservoir
12. Drain plug
13. Infrared light-emitting diode 14.Infrared light-receiving diode
---|---
(Product may be subject to change without prior nonce)
CONTROL PANEL
Button (with indicator) | Function |
---|---|
ADD WATER | The indicator lights in red when the water the reservoir is |
lack of water.
ICEFALL| The indicator lights in red when the ice basket is full.
POWER| The indicator lights in green when making ice.
**S**
| The indicator lights in green when select small ice.
L
| The indicator lights in green when select large ice.
ON/OF| Start or stop the appliance
SELECT| Select the ice size
BEFORE FIRST USE
- Unpack the appliance, then check and make sure that all the accessories including ice basket and ice scoop, etc. are complete. Please contact the client service department if some accessories are missed.
- Please ensure the ice maker is level and on a stable table or platform to avoid malfunction.
- The incline angle of the ice maker cabinet should not exceed 45° during transportation or use. Do not turn the ice maker upside down. Doing so could cause the compressor or refrigerating system to operate incorrectly. Please allow time for the fluids in the compressor to settle after the ice maker is moved or transported. Before using the ice maker for the first time, please wait for 2 hours after the unit has been leveled and positioned in the proper place.
- The appliance must be placed on a dry and level surface with sufficient ventilation, far from heat sources such as ovens, heaters and corrosive gases. Leave an about 8-inch clearance on all sides of the ice maker for proper ventilation.
- Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to fill the water reservoir with water of room temperature or lower.
- Do not use the appliance at a very cold environment (lower than 5°C).
- Clean the appliance by following the operation of “CLEANING AND MAINTENANCE” before operating.
USING YOUR ICE MAKER
-
Ensure that the drain plug at the bottom of the water reservoir is closed well.
-
Plug the ice maker into the wall outlet, and the “POWER” indicator blinks.
Note: Please make the ice maker be rested for 30 minutes before plug if it has been moved. -
Open the top lid and remove the ice basket.
-
WARNING: Fill the water reservoir with potable water only.
Note: Do not fill above the MAX water level mark. -
Replace the ice basket and close the top lid.
-
Press the ON/OFF key and the “POWER” indicator lights solidly.
-
The ice-making cycle will last approximately 8-15 minutes, depending on the ambient temperature and water temperature.
-
The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator. Over the next 8-15 minutes ice forms on the evaporator. Once this has been completed, the ice tray will tilt backward and the remaining water in the ice tray is drained back into the water reservoir. The ice cubes are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will automatically move back into position under the evaporator and start the next cycle.
-
The “ICE FULL” indicator will light up when the ice basket is full and the ice maker will stop the ice-making cycle automatically. Gently remove the ice from the ice basket
with the ice scoop. About 5 seconds later, the ice maker will restart its ice- making function automatically. -
The “ADD WATER” indicator will light up when the water reservoir is lack of water and the ice-making cycle will stop automatically. At that time, remove the ice basket and add water to the water reservoir, and then press the ON/OFF key again to restart the ice-making cycle.
-
When you have got your desired amount of ice, stop the ice-making cycle by pressing the ON/OFF key and unplugging the unit from the wall outlet.
-
Open the top lid and transfer the ice to a freezer.
-
Allow the ice maker to reach room temperature.
-
Suggest replacing the water every week. Please empty the water reservoir if the ice maker is not used for a long time.
CLEANING AND MAINTENANCE
To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning your ice maker at least once per week.
- Stop the ice-making cycle by pressing the “ON/OFF” key, unplug the ice maker from the wall outlet, and allow it to warm up to room temperature.
- If residual water is found in the ice tray, gently push the ice tray back so that all v water drains into the water reservoir.
- Move the appliance forward to a position 75mm away from the working table and open the drain plug to drain out excess water (see Fig.3, Fig.4, and Fig.5).
- Remove the ice basket.
- Clean the ice maker interior with a soft cloth dampened with warm water and vinegar. Rinse with a clean damp cloth.
- Put the drain plug back properly. Wash the ice basket and ice scoop in warm soapy water. Rinse and dry.
- Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap, if necessary.
NOTE: 1) Do not use organic solvent, boiled water, detergent, strong acid, and strong alkali, etc. for cleaning.
- Please empty the water reservoir and dry it for storage if the ice maker is not used for a long time.
TROUBLESHOOTING
Problem | Possible causes | Solution |
---|---|---|
ADD WATER indicator turns on | I . Low water level or lack of water |
2. The water screen at the bottom of the water reservoir is blocked.
3. Pump malfunction.| 1. Stop making ice, refill water and then press the
“ON/OFF” key to restart the ice-making cycle.
2. Do cleaning
3. Send it to the authorized
| | department for repair.
---|---|---
ICE FULL indicator lights up| 1. Ice basket is full and the infrared light is
blocked by the ice.
2. Infrared light-emitting diode & light-receiving diode do not work| 1.
Remove the ice from ice basket. 2a Wipe up the foreign objects on the infrared
light-emitting diode & light-receiving diode and restart the ice maker. 2b
Call Customer Service if the infrared light-emitting diode & light-receiving
diode still can not work after wiping up the foreign objects on them and
restarting the ice maker.
The ice maker stops working| The ice tray is not in the right position.|
Remove the ice in the ice tray and press the “ON/OFF” key to restart the
appliance.
2. Call Customer Service if the appliance still can not work after restart.
The ice basket is full but the “ICE FULL” indicator does not illuminate| The
“ice full” condition can not be detected as the infrared light module is
interfered by the sunlight.| Unplug the appliance and move it to a place that
is not exposed to the sunlight, then plug the appliance and activate it again.
The ice collects together.| Making ice takes too much time.| Stop making ice
and restart the ice-making cycle after the ice melts.
The water in the water reservoir is of too low a temperature.| Fill the water
reservoir with water ranges between 8°C and 25°C.
The ice-making cycle seems normal but no ice is produced.| The ambient
temperature or water temperature is too high.| Start the ice-making cycle at
an environment with an ambient temperature less than 32° C and fill the water
reservoir with some cold water.
---|---|---
Refrigerating system leaks| Call customer service
Refrigerating system blocks| Call customer service
Poor ice-making result| 1. Poor heat dissipation.
2. The water temperature is too high.
3. The ambient temperature is too high.| Leave an 8-inch clearance on all
sides of the ice maker for proper ventilation.
2. Fill the water reservoir with water ranges between 8°C and 25°C
3. Operate the ice maker at an environment with an ambient temperature
between 10°C and 32°C.
TECHNICAL PARAMETERS
Model: EP1069T-UL
Applicable climate: ST/SN/N/T
Class: I
Power source: 110-120V/60Hz
Rated power: 105W
Refrigerant/Refrigerant amount: R134a/68g
Foaming agent: CsH10
Net weight: 9.03Kg
Housing: Metal
Unit size (DXWXH): 348248295mm
CUSTOMER SUPPORT
Should you encounter any issues or if you have any questions regarding your
new product, feel free to contact our helpful Customer Support Team. Your
satisfaction is our goal!
Email: support®crownful.com
Support Hours
Monday – Friday:
9:00 am – 5:00 pm PST
- Please have your order invoice or order number ready before contacting customer support.
http://pro.crownful.com/
Scan to Follow Us
@crownful.official
@crownful.official
@crownful.official
@crownful.official
crownful.official
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>