FLAMMA FC07 Overdrive Pedal Owner’s Manual
- June 5, 2024
- FLAMMA
Table of Contents
FLAMMA FC07 Overdrive Pedal
Precautions
Please read carefully before proceeding
Power Supply
Please use power supply with ９V and at least 7mA current value for the unit.
Incorrect power suuply may cause short-circuit and damage.
Please turn off the power supply if the device is not used for long period.
Important Safety Instructions
- Read these instructions
- Keep these instructions
- Heed all warnings
- Follow all instructions
- Do not use this apparatus near water
- Clean only with a dry cloth
- Do not install near any ventilation openings. Install in accordance with the manufacturer’s instructions
- Do not install near any heat sources such as radiators, heat registers, stoves or other apparati (including amplifiers)that produce heat
- Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade of the third prong are provided for your safety. If the provided plug does not fit into your outlet consult an electrician for replacement of the obsolete outlet
- Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point
FCC certification
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation
Features
- 2 Working Modes: Warm/Hot
- True bypass switch
- Very small and compact design
- DC 9V adapter power supply
Top panel
- TRUE BYPASS Footswitch: Push down the footswitch to toggle between on and bypass status.
- ON/OFF LED: Shows the on/off status of FC07, when the LED is lit the effect is engaged.
- DC IN Power Jack: For power supply, use a 9-volt DC regulated AC adapter (plug polarity is positive on the barrel and negative in the center).
- INPUT Jack: 1/4” mono audio jack, for connecting guitar.
- OUTPUT Jack: 1/4” mono audio jack, outputs the signal.
- Mode Switch: Switch between W arm mode and Hot mode.
- VOLUME Knob: Adjusts the volume of the overdrive sound.
- TONE Knob: Adjusts the tone color of the overdrive sound.
- OVERDRIVE Knob: Adjusts the gain of the overdrive sound.
Effects Explanation
- Warm: Reconstruct a warm tube drive tone and nice dynamic response of classic tube amplifier, it provides a natural, smooth, creamy overdrive sound.
- Hot: More powerful output than Warm mode, mighty crunch tone.
Specifications
- Effects Modes: 2 (Warm, Hot)
- Input: 1/4” monaural jack (impedance: 500k Ohms)
- Output: 1/4” monaural jack (impedance: 10k Ohms)
- Power Requirements: AC adapter 9V DC (center negative)
- Current Draw: 7 mA
- Dimensions: 47mm (D) × 83mm (W) × 52mm (H)
- Weight: 153g
- Accessories: Safety Instruction & Warranty Card Sticker quick guide.
- Notice: Recommend to use isolated/individual power supply. Sharing power supply with other pedals may cause unexpected noise.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>