Lumens 43-LT02B Solar Rock Spot Light User Guide

Lumens 43-LT02B Solar Rock Spot Light

Safety Information

• WARNING: Do not submerse the solar rock spot  light in water or mount it recessed into the ground.
• WARNING: Your solar light may not function in temperatures below -4ºF (-20ºC) or above 140ºF  (60ºC).
• CAUTION: Use rechargeable batteries only.  Recycle or dispose of batteries properly.
• CAUTION: Do not open, short circuit, or mutilate batteries as injury may occur.

Warranty

ONE YEAR LIMITED WARRANTY

WHAT IS COVERED
The manufacturer warrants this product to be free of defects in material and workmanship for a period of one (1) year from the date of purchase. This warranty only applies to the original consumer purchaser and only to products used in normal use and service. The manufacturer’s only obligation and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modification, alternation, neglect, or mishandling. Proof of purchase and evidence of manufacturer’s date coding must accompany all warranty claims. Manufacturer’s date coding is printed and adhered to each product.

WHAT IS NOT COVERED
This warranty does not apply to products that are found to have been improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the product. This warranty does not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation. Batteries supplied with this product are not included in this warranty. This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty contained herein. This warranty does not cover consequential or incidental loss or damage, including but not limited to any labor/expense costs involved in the replacement or repair of the product.
Contact the Customer Service Team at 1-830-249-1200 or CustomerService @Creative-prc.us

Pre-Installation

PLANNING INSTALLATION

Ensure the mounting location for your solar spot light allows the solar panel to receive direct sunlight. Do not locate the product in shaded areas as this will significantly reduce performance. Position the spot light such that during evening hours the ambient light from other light sources does not affect the photosensor built into the lamp. High ambient light levels can cause the lamp to turn off during evening hours.
NOTE: The solar light is equipped with a photosensor that turns the unit on at dusk and off at dawn. Ambient light can affect the operation of the photosensor.

TOOLS REQUIRED

• Phillips Screwdriver

PACKAGE CONTENTS

Operation

WARNING: Do not submerse the solar rock spot light in water or mount it recessed into the ground.

• Your solar rock spot light is fully assembled in the package. Remove the plastic sheet covering the solar panel and place in an area where the solar panel is exposed to direct sunlight.
• Your solar light is equipped with a 3-way selector (3000K, OFF, and 5000K) on the bottom of body. Prior to use, the selector must be set to 3000K (or 5000K) and allowed to charge a full sunny day.
• After a full day charging in the sun, choose your preferred LED color (3000K for soft white and 5000K for bright white).
• The unit will automatically turn on at dusk.

Maintenance

Replacing the battery

NOTE: Use one 18500 Lithium Phosphate, 1000mAh, 3.2V rechargeable battery. For best performance, replace with a Lithium phosphate rechargeable battery(s) every 18 months.
IMPORTANT: Dispose of the battery in accordance with local, state, and federal regulations.
IMPORTANT: When storing any solar product for an extended period of time, remove the batteries. Storing any solar product without regular recharge or removal of batteries could cause permanent damage to the rechargeable batteries.

• Remove the battery cover by unscrewing the four screws.
• Remove the old battery. Replace with a new 18500, 3.2V Lithium Phosphate rechargeable battery – The recommended replacement battery capacity should be 1000~1500mAh.
• Replace the battery cover with the four screws. Also remember to replace the rubber gasket and switch rubber boot along with the battery cover.

Care and Cleaning

• The solar panel should be cleaned periodically with a damp cloth to help maintain optimum performance.
• Do not use any cleaners with chemicals, solvents, or harsh abrasives.

Troubleshooting

that the solar light is located in an area where it can receive the maximum amount of full, direct sunlight every day. Keeping the solar panel clean is equally important to ensure the maximum charging performance.
The battery is reaching the end of its useful life.| Replace the old battery with a Lithium phosphate rechargeable battery.
The solar light does not turn on at night.| Your solar light is equipped with a 3-way selector (3000K, OFF, and 5000K) on the bottom of body. The selector must be set to 3000K (or 5000K) prior to use.| Prior to use, check that the unit has been set to 3000K (or 5000K) and allowed to charge a full sunny day.
The solar light is installed close to other light sources, which may keep the solar light from turning on at night automatically.| Relocate the fixture or eliminate other light sources.

Service Parts

Part| Description| Quantity| | Part| Description| Quantity
---|---|---|---|---|---|---
A| Spot light head assembly| 1| F| 3-way selector| 1
B| Resin body| 1| G| Battery| 1
C| Battery compartment| 1| H| Rubber boot| 1
D| Rubber gasket| 1| I| Battery cover| 1
E| Screws| 4|

References

• Your New Address on the Internet!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>