KERBL 297902 Boss II Gloves User Manual
- June 3, 2024
- KERBL
Table of Contents
KERBL 297902 Boss II Gloves
Instructions for use
Results of the EN 388:2016+A1:2018 mechanical test
Abrasion resistance: 3 (min 0 / max 4)
Blade cut resistance (Coupe – Test): 1 (min 0 / max 5)
Tear resistance: 4 (min 0 / max 4)
Puncture resistance: 2 (min 0 / max 4)
Blade cut resistance (TDM): X (min A/max F) The sign X, instead of a
number, means that the glove is not designed for the use covered by the
corresponding test.
Care and Cleaning:
The service stages mentioned are based on tests that were carried out
exclusively on unused gloves. Transfer of the results on gloves aftercare
treatment is not possible. The manufacturer accepts no liability for changes
to the properties. For donning, check the integrity of the glove and the
picked size that fits the hand. For doffing, ease the glove of one hand before
removing the second glove to reduce the risk of contamination.
Packaging and storage:
This article is supplied in uniform sales packaging made from recyclable
cardboard. PE bags or similar environmentally friendly coverings are the
smallest packaging unit. The gloves must be stored correctly, i.e. in boxes in
dry rooms. The properties can be altered by influences such as humidity,
temperature, and light, as well as natural alterations to the materials over a
period of time. Aging: It is not possible to give an expiry date, as this can
be dependent on the degree of wear, use, and the area in which the gloves are
used.
General information / Risk assessment: The glove types named
here meet the requirements of Regulation (EU) 2016/425 as brought into UK law
and amended, and is compliant with the above-mentioned harmonized/designated
standards EN ISO 21420:2020, EN 388:2016+A1:2018. While selecting equipment,
the user should perform risk analysis based on the intended use and determine
suitability based on the product’s test standards and protection levels
obtained. Laboratory tests offer aid to the selection, however, they cannot
take the actual workplace conditions into account. It is therefore the
responsibility of the user and not the manufacturer to test the suitability of
a certain glove for the planned area of use. Gloves for general light handling
in wet conditions. The equipment provides protection against moderate
mechanical risks. The maximum wear time depends on the activity being carried
out and the person. The glove offers no protection against perforation with
sharp objects, e.g. injection needles. No gloves should be worn if there is a
risk of becoming caught in moving machine parts.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>