B O W HB357-3 Bluetooth Keyboard Instruction Manual
- June 4, 2024
- B O W
Table of Contents
B O W HB357-3 Bluetooth Keyboard
Product display
- Power Indicator
- Numlk indicator
- Pairing indicator
-
- Upper and lower case indicator
Bluetooth channel pairing connection steps
- Turn on the power switch of the keyboard, the indicator light stays on for 3 seconds and then turns off.
- Long press the Bluetooth channel 1 ( ) of the keyboard, the pairing indicator will flash blue slowly; enter the pairing state,
- Turn on the Bluetooth of the tablet and search, the tablet itself or manually search to find the keyboard name (Bluetooth name: B.O.W), click connect;
- A successful connection will appear and the keyboard status indicator will turn off.
Note:
- The connection method of Bluetooth channel 2 ( ) and channel 3 ( ) is the same as that of 1.
- Switch channel: Just click the corresponding bluetooth channel
- Reconnect: Tap the corresponding Bluetooth channel
- The 180S unpaired keyboard will go to sleep, and then you need to press the corresponding bluetooth channel when pairing again.
Instructions for use of function keys
keyboard parameters
Power-saving sleep mode
When the keyboard does not have any operation command within 30 minutes, it will automatically enter the sleep mode. When you need to use it, you only need to press any key and wait for ÿ4 seconds, the keyboard will wake up and the keyboard can work normally.
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.