aandss S120SE Cordless Vacuum Cleaner User Manual
- June 5, 2024
- aandss
Table of Contents
Cordless Vacuum Cleaner S120SE
User Manual
Important Safety Instructions
- Note: Please read the instructions carefully before use. Don’t use it outdoors on rainy days.
- Warning: Safety precautions are essential when using any household appliances, including but not limited to fire disasters, short circuits, and personal injury prevention.
Personal Safety
- Please store the machine in a dry area indoors and away from children.
- Children over 10 years old and people with physical or mental disabilities must use it under supervision.
- Please do not allow children under 10 years old to touch the machine, and keep away from children under 10 years old when using and maintaining the machine.
- Please use the attachment recommended in the package. Wrong use or other mismatched attachments may cause personal injury or harm.
- Pay extra attention when cleaning the stairs.
- Keep the machine away from hot surfaces.
- Please be sure to keep the air inlet unobstructed, away from fluff, cloth, and other things easily blocking the machine.
Electrical Safety
- Please use the battery and charger provided in the package.
- Please do not change the charger in any way.
- Please ensure that the input voltage is consistent with the marked voltage on the charger.
- The charger and battery are compatible with each other. If the charger of other specifications is used, it may cause fire risk.
- Please check the power cord of the charger for signs of damage and aging before use. Damaged or tangled electrical appliances will increase risk of fire and short circuit.
- Please treat the charger power cord correctly.
- Do not pick up the charger through the charger line.
- Please do not pull the charger by pulling the charger line. You should hold the charger by hand for plugging and unplugging.
- Do not store the charger by winding the charger cable on the charger.
- The charger line must be away from hot surfaces or sharp objects.
- The charger line cannot be replaced by yourself. If the charger line is damaged, please contact the after-sales service for replacement.
- Do not touch the charger or the whole machine with wet hands.
- Do not store or charge the machine outdoors.
- When loading and unloading the battery or cleaning and maintaining the machine, be sure to remove the charger from the charging plug.
Battery Safety
- This product uses a lithium battery, do not burn it or expose it to a high-temperature environment.
- Please use the original battery, replacing with the wrong battery may cause danger.
- Do not remove or collide the battery to avoid leakage of liquid in the battery.
- In extreme cases, the battery may leak. Do not touch any liquid leaking from the battery. If liquid gets on your skin, wash it immediately with soap and water. If liquid enters the eye, flush immediately with water for at least 10 minutes and seek medical attention. Handle the battery with gloves and dispose of it immediately according to local regulations.
- Short-circuit battery terminals may cause burns or fire.
- When the battery pack is not in use, stay away from paper clips, coins, keys, nails, screws or other connecting ends small metal objects.
- When you handle the appliance, please take out the battery and handle the battery safely according to local regulations.
Services
- Before and after use of the appliance, check whether there are signs of wear, damage and repair as necessary.
- Do not use the appliance if it is damaged or defective.
- The maintenance work shall be carried out by the service organization or personnel meeting the relevant safety regulations. Repairs by unqualified people can be dangerous.
- Do not modify the appliance in any way to avoid increasing the risk of personal injury.
- Use only replacement parts or accessories provided or recommended by the manufacturer.
Introduction to Product Components
Machine Operating Instructions
-
Press the On/Off button, the machine starts, the work starts in first gear by default, then press the speed switch, the machine switches to high-grade work.
-
On the right side of the brush is a water spraying switch, it will spray water after pressing. On the left side is the UV lamp switch, UV lamp starts to work after pressing.
Method of Use
-
Machine Assembly Instructions
First insert the water tank assembly onto the ground brush, pay attention to the female plug on the water tank to be positive with the male interface on the ground brush.
-
Plug the elongated tube into the water tank assembly, press down firmly after aligning the interface, and then plug the pre-prepared host to the other end of the extended tube.
-
The water tank is filled with water from the filling port, then the lid of the water tank is tightened and the two sides of the water tank are clamped on the machine.
-
Finally, mount the two fasteners of the front transparent cover onto the floor brush, and press on the top to clip.
-
When the waste water tank is full of water, rotate the drain button in the figure below and remove the wastewater from the drain port.
Use with a Push Rod
a) Insert the electric catheter into the suction socket until the snap of the
lock is heard “pa”. 17
b)
Insert the floor brush into the other end of the catheter until the snap of
the lock is heard “pa”.
c) Press the switch to start work.
2 Levels of speed change control A. Low speed – One press of the IQ switch is
low speed B. high-speed – Press the speed switch to change to high speed.
Use Hand Held
Insert the attachment directly into the suction socket until the snap of the
lock is heard Pa
Install the accessories on the host as shown in the figure below.
Charging
When the battery level indicator flashes, turn off the appliance, then put it
back on the charging base and charge it as shown. 
Flashing
When the power indicator is all on and no longer flashing, it means the power
is full.
How to Clean up Garbage
Press the latch and remove the pipe. Open the dust cup. Pour out the dust.
How to Maintain
-
Open the dust cup, as shown below.
-
Rotate counterclockwise and remove the cyclone filter.
-
Filter cotton and filter hood can be washed with water.
-
After drying the cyclone filter, install it clockwise back into the dust cup. And Cover the bottom of dust cup.
Product Parameters
| The Battery | 22.2V/2500mAh |
|---|---|
| Charging Time | 4 Hours |
| Adapter Output | 27V =0.65A |
| Working Time | 40 minutes |
| Power | 250W |
| Suction Power | 20000 Pa |
| The Adapter | VDE/1.8M |
Troubleshooting Measures
The effect of dust absorption is not ideal:
- Empty the dust cup.
- Check whether the dust cup is correctly assembled.
- Check whether the filter and screen are properly placed.
- Clean the filtration system.
Stop working:
- Charge your battery.
- Clear the floor brush blockage.
The battery won’t charge:
- Please check whether the charging head is connected properly.
- Please check the socket.
If water is found in the dust cup of the main body during use, please stop
using immediately.
When washing the floor, please use the water tank and ground brush. The normal
floor brush for dry dust.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>