claber 90474 Medium-Jet Turbine Sprinkler Instruction Manual
- June 3, 2024
- claber
Table of Contents
claber 90474 Medium-Jet Turbine Sprinkler
DETAILED POINT AND SHOOT SETTING INSTRUCTIONS
Install sprinkler on pipe with nozzle arrow (A-nozzle arrow) facing away from you
INSTALLATION STEPS
-
SET NOZZLE TURRET TO IT’S STARTING POSITION
-
Using your thumbs rotate the top of the sprinkler completely to the right until it clicks. Then rotate it completely to the left until it clicks. The nozzle arrow (A-nozzle arrow) is now at its left starting position
-
SET LEFT START.
-
Insert key into pull up slot (B-pull up slot). Turn key 1/4 turn and pull up riser (C-riser) completely.Hold lower half of riser (C-riser) and turn lower half of riser until nozzle arrow (A-nozzle arrow) is pointing to yourdesired starting position. Release riser. The sprinkler will begin spraying at this starting point
-
SET RIGHT STOP.
Hold the top of the sprinkler at the left start position with your danger (to keep it from rotating), and insert K-Key or small flat blade screwdriver into arc adjustment control (D-arc adjustment control). Turn clockwise to increase arc and counterclockwise to decrease arc.
NOTE:
The arc set arrow (G-arc set arrow) in the center will rotate to your desired stop point or degree setting. -
REDUCING SPRAY DISTANCE.
See nozzle arrow (A-nozzle arrow).Insert key into nozzle breakup screw (E-nozzle turret) and turn clockwise
COD. 12311 Rev. 00 12/2018
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>