EVONIC Lindstrom DS Double Sided Electric Fire Instruction Manual

EVONIC Lindstrom DS Double Sided Electric Fire

EU DIRECTIVES

All EvAll Evonic Fonic Firires pres products meet the requirements elements of the EC Dir the EC Directivectiveses.. These dishes directive has have been met be been met by compliance with the fy compliance with the following stand following standards:ds: EU 2011-65/EU 2015/863 REU 2011-65/EU 2015/863 Restriction restriction of Hazar Hazardous Substancesdous Substances. References to the rences to the relevant designate designated standard standards used:

• EN 55014-1:2006 + A1:2009 + A2:2011 ElectrEN 55014-1:2006 + A1:2009 + A2:2011 Electromaomagnetic Compagnetic Compatibilitytibility..
• EN 55014-2:2015 ElectrEN 55014-2:2015 Electromaomagnetic Compagnetic Compatibilitytibility..
• EN 61000-3-2:2014 ElectrEN 61000-3-2:2014 Electromaomagnetic Compagnetic Compatibility (EMC). Limitstibility (EMC). Limits. Harmonic CurHarmonic Currrent Emissionsent Emissions.
• EN 61000-3-3:2013 Electromagnetic Compatibility (EMC). Limits. Limitation of Voltage Changes, Voltage Fluctuations and Flicker.
• EN 60335-1:2012 + A11:2014 Household and similar electrical appliances – Safety
• EN 60335-2-30:2009+A11:2012 Household and similar electrical appliances. Safety. Particular requirements for room heaters

UKCA STANDARDS

All EvAll Evonic Fonic Firires pres products are in in conformity with the enormity with the relevant UK Staant UK Statutory Instrtutory Instrumentsuments (and their amendments)

• 2016 No. 1101 The Electrical Equipment (Safety) Regulations 2016
• 2016 No. 1091 The Electromagnetic Compatibility Regulations 2016
• 2012 No. 3032 The Restriction Of Use Of Certain Hazardous Substances In Electrical And Electronic Equipment Regulations 2012

IMPORTANT INFORMATION AND HEALTH & SAFETY

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

• Read all of the instructions carefully before using the appliance, only use this appliance as described in this manual. Any other use not recommended by the manufacturer may cause injury to persons, or damage to the appliance.
• Remove all packaging and dispose of it at an appropriate recycling facility.
• When transporting or storing the appliance and power lead, keep in a dry place, away from excessive vibration and store so as to avoid damage.
• This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.
• DANGER: High temperatures may be generated under certain abnormal conditions.
• Do not install this appliance immediately in front of a fixed socket outlet.
• Do not install this appliance in the immediate surroundings of a bath, shower, swimming pool or any other area where the appliance could come into contact with water or humidity, e.g. a bathroom.
• Do not use in areas where gasoline, paint, or any flammable liquids are used or stored.
• This appliance is only suitable for indoor use, do not use outdoors.
• Do not cover the appliance, or let the air inlet/outlet to be obstructed in any way as it may overheat.
• Keep the power lead away from hot surfaces and the heater outlet. Do not route the power lead in front of the appliance, or under any carpets or rugs.
• A maintenance hatch must be installed into the surrounding installation to allow future access.
• Always use a certified electrician should new circuits or outlets be required. And always use properly grounded, fused and polarised outlets.
• Where the power lead passes through any masonry wall, stone surround etc. ensure that suitable rubber bushes are fitted at any possible wear points.
• If the power lead is damaged do not use the appliance until it has been replaced.
• Do not use any external switching device, timers, or extension leads. Do not connect the appliance to a circuit that is frequently switched on and off by the utility.
• In the event of a malfunction, switch off the appliance, and disconnect it from the mains power supply. Have the appliance inspected by a certified electrician before reusing.
• Do not use the appliance if it is damaged. In the event of any damage to the appliance, please contact the retailer from whom the appliance was purchased.
• Any repairs must only be performed by a certified electrician. Extreme caution is necessary when any heater is used by, located near children or people of reduced mobility, and whenever the unit is left operating and unattended.
• Young children should be supervised to ensure that they do not play with the appliance.
• Disconnect from the power supply before performing any cleaning, maintenance or relocation of the unit. Do not use steam cleaners, or aerosols near the apliance.
• Do not burn wood or anything else in this appliance.
• Do not strike the glass
• Do not drill or screw any new holes into the appliance.

COMPONENTS

Model

|

Log Sets & Quantity

|

Glass Stones Clear & Amber

|

Black Vermiculite

|

Suction Lifter

|

Electrical Lead

|

E-Series Instruction Manual

---|---|---|---|---|---|---
Woodland or Silver Birch
Lindstrom DS| 4 x large| 4 x Clear

4 x Amber

| 5 x| 1 x| 1 x| 1 x

INSTALLATION

MODEL DIMENSIONS

INSTALLATION REQUIREMENTS

Before installing the appliance please read and take into account the following important requirements;

• Consult a qualified professional to check the structure of the installation site.
• The appliance must not be installed anywhere that it may come into contact with water, i.e. a bathroom.
• Do not use silicones or adhesives to seal in the appliance, and do not apply wet plaster directly to the appliance.

CHECKS BEFORE INSTALLATION
We recommend turning on the appliance before installation, connect the appliance to a power source using the provided electrical lead, and depress the right side of the rocker switch. Remove the electrical lead from the wall and continue with the installation.

TOOLS REQUIRED

• Tape Measure
• Pencil
• Spirit Level
• Screwdriver
• PZ2 Screw Bit

INSTALLATION STEPS

1. Remove the two bottom mounted transit brackets from both sides. You will not need these for the installation.
2. Determine the finished height and position that you want the appliance to be located. Build your base support taking into consideration the 50mm ventilation gap under the appliance. Then place the appliance onto the support and check that it is well supported.
3. Your plasterboard can now line up with the plaster kits on the edge of the appliance.
4. Your installation is now complete and you can set up your logs.

LOG LAYOUTS

When you have your appliance installed you can set up your log sets. If your model comes with Chippings, Glass Stones and/or Vermiculite lay this on the fuel bed first, then continue with laying out your logs. The following images show an example of how you could lay them out.

INSTALLING / REMOVING THE FRONT GLASS

1. Unscrew and remove the glass retainer panel.
2. Apply the Suction Lifter to the glass and place the bottom edge in first, then angle the top edge into the appliance. Then replace the top retainer panel.

TROUBLESHOOTING

Evoflame Only- LED Strip Replacement Scan the QR code to be taken to a video in our maintenance series. Please note; this video shows an old method of removing the front glass panel. Refer to page 25 for the new method. Fan Re- setting& Replacement Scan the QR code to be taken to a video in our maintenance series. Please note; this video shows an old method of removing the front glass panel. Refer to page 25 for the new method. Heater Access &Replacement Scan the QR code to be taken to a video in our maintenance series. Please note; this video shows an old method of removing the front glass panel. Refer to page 25 for the new method. E-Smart Only E-Smart LED Replacement Scan the QR code to be taken to a video in our maintenance series. Please note; this video shows an old method of removing the front glass panel. Refer to page 25 for the new method.

REPORT A FAULT
If you have any difficulties or problems with your appliance then please get in touch so that we can assist you. Please scan the QR code to be taken to our websites Report a Fault page, we will then be in touch with you shortly.

WARRANTY EXCLUSIONS AND LIMITATIONS

The Evonic Extended Warranty does not cover:

1. Damage resulting from installation and usage where the appliance has not been installed
   or used in accordance with the CK Fires Ltd installation and operation instructions, or if the installation does not conform to local building, fire, and safety regulations.

2. Issues with mains/spur connections of power supply.

3. Damage resulting from the product not being adequately maintained. (Please see your CK Fires Ltd Installation and Operating Instructions for further information on how to service and maintain your appliance).

4. Damage caused by unauthorised modifications, use or repair.

5. Damage or defects caused by the product being stored in a damp, unheated environment.

6. Consequential loss (to the extent permitted by the law) relating to other associated products that have not been supplied by CK Fires Ltd.

7. Consequential loss (to the extent permitted by law) related to decorations, furnishings, or other household assets.

8. Removal and re-installation costs.

Repaired or replaced products are covered only for the remainder of the original warranty period. In the event of a claim being made, this must be reported to your retailer or CK Fires Ltd within 14 days of the fault occurring/being noticed. In the event of a product fault occurring during the warranty period years 2-5, CK Fires Ltd will send the appropriate component or goods necessary to rectify the fault, free of charge. Nothing in the Extended Warranty shall make CK Fires Ltd liable for any or special, incidental, or consequential damages, injury to persons or property, or any other consequential loss beyond the consumer’s statutory rights. The liability on these issues is covered by our Terms and Conditions of Sale. CK Fires Ltd total liability extends only to the purchase price paid for the goods, except where such a limitation is prohibited by statute. CK Fires Ltd, in the event of a warranty claim, reserves the right either to replace the goods in question or to refund the purchase price of the goods. For product sold outside the UK and Ireland, UK law will prevail. The Evonic Fires Extended Warranty does not affect your statutory rights.

CK Fires Ltd / Evonic Fires
1, Evonic House, Clifford Park, Clifford Lane, Stratford-on-Avon, CV37 8HW
Tel: +44 (0)1789 263868 Fax: +44 (0)1789 293080 Email: sales@evonicfires.co.uk www.evonicfires.co.uk

Follow us on:
Instagram | Facebook | Twitter | LinkedIn @evonicfires

References

• Register Your Product - Evonic Fires
• Electric Fires, Stoves & Inset fires - Evonic Fires

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>