Aduro PW-10KQI Power Bank Instructions
- June 5, 2024
- ADURO
Table of Contents
Aduro PW-10KQI Power Bank
Product Overview
Brief introduction:
- Output 1: 5V/1A
- Output 2: 5V/2A
- Micro USB Input: 5V/2A
- Power button ON/OFF (Switch Button)
- Type C Input: 5V/2A
- Wireless Charging Output Area
- 4 LED lights to indicate battery capacity(1 LED light on means 25% battery capacity, 2 LED lights on means 50% battery capacity, 3 LED lights on means 75% battery capacity, 4 LED lights on means 100% battery capacity) 1 Pink LED light to indicate while there is Wireless Charging
Use Operation
Charge other devices
-
(a) Use a suitable cable to connect the power bank and other device together to charge
(*Remarks: This charged device is suitable for 5V charge voltage) -
(b) Before the 1st use, suggest to fully charge power bank at first.
-
(c) Put a Smartphone which have Qi Wireless Charging function to the area (6), put at the center place to make sure the wireless charging is high efficiency.
Charge power bank
- (a) Use the Micro USB Cable or Type C Cable to connect power bank and 5V adaptor(or computer or other power sources) to charge power bank
- (b) During charging power bank, 4 LED lights is flashing: 1 LED light flashing means 25%battery charging inside, 2 LED lights flashing means 50% battery charging inside, 3 LED lights flashing means 75% battery charging inside, 4 LED lights flashing means 100%battery charging inside. After fully charged, LED light will stop flashing and become 4 LED lights always on.
FCC Statment
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to
radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-
located for operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>