eMoMo P4 Wireless Charging Holder User Manual
- June 5, 2024
- eMoMo
Table of Contents
P4
User Manual
Caution
- Before use of unit, please read the Manual carefully.
- Keep the product away from water, liquid, or wet area.
- Keep the product away from naked flame.
- The unit should be powered off before unplugging.
- Do not place the product in direct sunlight or heat. Keep away from temperatures over 35°C.
- Do not attempt to remove the unit. To remove panel or attempt to repair the unit could result in potential electric shock.
- Do not insert foreign objects into the product.
- Adult Supervision is recommended if children are using this product.
Wireless Charging Holder
Drawing
Specifications
Wireless Charging: 5V, 1A.
USB: 5V, 4A.
Installation
-
Drill hole
-
Install screws
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>