Power7 Technology GODNESS Smart Visible Blackhead Remover User Manual
- June 5, 2024
- Power7 Technology
Table of Contents
Power7 Technology GODNESS Smart Visible Blackhead Remover
product information
product specification
Product specifications
FCC
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device was tested for typical body-worn operations. To comply with exposure requirements, a minimum separation distance of 0cm must be maintained between the user’s body, including the antenna. Third-party belt clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that donot meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied oran approved antenna. The highest SARlevelmeasured for this device is 0.48W/kg(Head)
Introduction to working mode
- Switching order of working mode:
- **** Mode key switching order:
- Connect to mobile phone APP: visual care mode –→ bactericidal and antiinflammatory mode –→ visual care mode;Ii. Mobile phone disconnected: non-visual nursing mode –→ bactericidal and anti-inflammatory mode –→ non-visual nursing mode;
- In case of mobile phone connection: 1) Enter visual nursing mode by default;2) Manually switch to the sterilizing and anti-inflammatory mode; 3) Vibration reminder for 5 minutes;
- Visual care mode: enter the mode when connected to the mobile phone, turn on the vacuum pump, camera, and white light-filling LED, and send the video to the mobile APP to check the blackhead suction process. You can take photos or record videos in this state;
- Non-visual nursing mode: in the state of not answering the phone, it will enter by default. The vacuum pump blackhead suction nursing mode will be turned on, and the camera will not work (the light-filling LED will not be turned on by default);
- Sterilization and anti-inflammatory mode: the working time of this mode is not limited. The motor stops working and blue light is turned on by default for sterilization and anti-inflammatory;
- Overtime reminder in nursing mode: in the nursing model, after the motor has worked for 5 minutes, a prompt box will pop up on the mobile APP to prompt consumers to pay attention to the care time so as to avoid skin damage. The vacuum pump motor stops for 500 milliseconds and works for 500 milliseconds and circulates for 3 times to remind consumers when it does not take over;
Definition of the suction tap of the nozzle
