Hoopo Protector Mounting User Guide
- June 5, 2024
- Hoopo
Table of Contents
Hoopo Protector Mounting
Protector Mounting Guidelines
- Place & attach the label on the installation surface at the selected position.
- Drill guiding holes 1&2 with 4.8 mm ( 3/16″) bit.
- Place the hooposense unit inside the protector in one of two optional positions;
- A – Suitable for vertical installation surface (gps antenna points to the sky).
- B – Suitable for horizontal installation surface (gps antenna points to the sky).
- Use 2 hexagon head drilling screws and washers.
- Screws DIN 7504K-Z.P 6.3X50 (#14×2″); Washers DIN 125A Part1 – Z.P. 8mm (5/16)
- Note: Please do not over-tight the screws.
Protector Installation Label
Position A – Suitable for vertical installation surface (gps antenna points to the sky)
Position B – Suitable for horizontal installation surface (gps antenna points to the sky)
Documents / Resources
|
Hoopo Protector
Mounting
[pdf] User Guide
Protector Mounting
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>