502G1000-1A HoopoSense Tracker Instruction Manual
- June 9, 2024
- Hoopo
Table of Contents
502G1000-1A HoopoSense Tracker
Instruction
TOP COVER REPLACEMENT
FIGURE 4 : PLACING THE COVER
PLACE AND HOLD THE TOP ON THE ENCLOUSER .
- Note: Pay attention to the batteries’ springs direction. Ensure rubber seal is in place.
FIGURE 5 : TOP COVER SCREW
TIGHT THE 4 TOP COVER SCREWS USING A SIMPLE PHILI S # 1 SCREW DRIV E R
- Note: Do not overtight. Use tightening torque 1Nm maximum
BATTERY INDICARTION
1-2 seconds after batteries installation, the hoopoSense tracker beeps three
times- indicating proper batteries insertion.
FIGURE 6 : HoopoSense SERIAL NUMBER
REPORT VERIFICATION
1-2 minutes after batteries installation, the hoopoSense tracker should report to the hoopoDashboard
- Note: First activation may take up to 4 minutes.
VERIFICATION BY SERACHING
Search for the hoopoSense tracker serial number (Shown as BCCDXXXX. Printed on the hoopoSense tracker sticker, see image below) and then by checking that the time appears in the “Last Report” Field (See image below) is matching the actual activation time. Notice that other data fields might show inaccurate data until the first proper utilization is done.
FIGURE 7 : ACTIVATIONINDICATION ON THE HOOPO DASHBOARD
MECHANICAL SPECIFICATIONS
HOOPOSENSE TRACKER
FIGURE 8 : HOOPOSENSE OUTL INE DRAW ING
PROTECTIVE COVER ( BUMPER )
FIGURE 9 : PROTECTIVE COVER
FIGURE 10 : PROTECTIVE COVER OTLINE PROTECTIVE
ALLR IGHT RESERVED • HOOPO SYSTEMS • 2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>