S02 HoopoSense Tracker Instruction Manual

: June 9, 2024
: Hoopo

Table of Contents

502G1000-1A HoopoSense Tracker
ASSOCIATION TOOL
FCC
APPENDIXA
APPENDIX B
Read User Manual Online (PDF format)
Download This Manual (PDF format)

502G1000-1A HoopoSense Tracker

ASSOCIATION TOOL

The association tool enables you to set the name and type of your asset, so they will appear on the hoopoDashboard instead of the hoopoSense tracker’s serial number.

FIGURE 19 : HOOPO DASHBOARD – ASSET NAME AND TY PE

Enter the association tool via mobile or desktop by clicking this link : app.hoopo.tech
Log in with the username and password you’ve received from the hoopo team.

Find the hoopoSense tracker by typing its serial number in the ‘DeviceID’ tab
Type the ‘Asset Name’ on which this tracker is installed
Choose the ‘Asset Type’ of this asset, if relevant.
Click submit.
If the details were updated successfully, you’ll see a success message.
Note: if you don’t see the success message, verify the details and your internet connection, and try again.

View the changes in the hoopoDashboard
Note: it may take a few minutes, you can refresh the page by clicking the refresh button.

FCC

FCC ID: 2A7ZU-S02
Contains FCC ID: XMR201910BG95M3
Contains FCC ID: 2AC7Z-ESP32WRWOM32E
IC: 28836-S02, HVIN: S02
Contains IC: 10224A-201910BG95M3

CAN ICES-003 (B)/ NMB-3 (B)
The FCC Wants You to Know
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician.

CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.

FCC Warning (Modification statement)
Hoopo has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

This device may not cause interference, and
This device must accept any interference, including interference that may cause undesired operation of the device.

Wireless notice
This device complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF)
Exposure Guidelines and RSS‐102 of the ISED radio frequency (RF) Exposure rules. This transmitter must not be co-located or operating in RF Exposure This device is only authorized for use in a mobile application. At least 20 cm of separation distance between the hoopoSense device and the user’s body must be maintained at all times.