INVENTUM STS725RC Stick Vacuum Cleaner Instruction Manual

June 5, 2024
INVENTUM

INVENTUM STS725RC Stick Vacuum Cleaner

1 safety instructions

  • Please read these instructions before operating the appliance and retain for future use.

  • The appliance is intended solely for domestic use within the home.

  • This appliance may be used by children from the age of 16 and up, and also by persons with a physical or sensorly limitation, as well
    as mentally limited persons or persons with lack of experience
    and knowledge. But only on the condition that these persons have received the necessary instructions on how to use this appliance in a safe way and know the dangers that can occur by using this appliance.

  • Children should be supervised to ensure that they do not play with the appliance.

  • Maintenance and cleaning of the appliance may not be done by children, unless they are older than 16 years old and are under supervision.

  • Keep the appliance out of reach of children younger than 16 years old.

  • Keep the appliance out of reach of animals and human body parts when the appliance is activated, to prevent to damage to skin, eyes or ears.

  • This appliance is intended to be used in household and similar applications such as:

    • Kitchen areas for personnel of shops, offices or other similar professional surroundings;
    • Farm houses;
    • Hotel or motel rooms and other surroundings with a residential character;
    • Guest rooms or similar.
  • Attention: the appliance cannot be used with an external timer or a separate remote control.

  • Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance.

  • Never let the power cord of the appliance hang over the edge of a table or counter, touch hot surfaces or become knotted.

  • Never use the appliance when the cord or plug is damaged, after malfunction or when the appliance itself is damaged. In that case, return the appliance to the point of sale or contact the Customer Service Department in order to avoid a hazard.

  • Close supervision is necessary when the appliance is used near or by children.

  • The use of accessories that are not recommended or sold by Inventum can cause fire, electrical shock or injuries.

  • The brush and vacuum cleaner are specially designed for use on carpet and hard floors. In some cases, and depending on the type of floor, scratches can occur on the surface which is cleaned. Inventum can not be held responsible for damage to the floor.

  • Unplug the appliance when it is not in use, before assembling or disassembling any parts and before cleaning the appliance. Put all buttons and knobs into the ‘off’ position and unplug the appliance by grasping the plug. Never unplug by pulling the cord.

  • Never leave the appliance unattended when in use.

  • Never place this appliance on or near a hot gas stove or electric burner or where it could touch a heated oven or microwave oven.

  • Do not vacuum water and inflammable materials.

  • Do not vacuum burning materials and ashes.

  • Do not use the appliance outdoors.

  • Keep hands, feet, loose clothing and hair out of reach of the rotating brushes.

  • Only use the original adaptor which is included. The technical details can be found on the rating label of the appliance.

  • Make sure the vacuum cleaner is off, when you charge it.

  • Do not charge the battery at temperatures above 37°C or below 0°C.

  • Static electricity: some types of carpet can cause static electricity. A discharge of static electricity is not dangerous.

  • Do not use the appliance for cleaning wet surfaces or to vacuum wet substances.

  • Always use the appliance on a secure, dry, level surface.

  • When the appliance is used for other purposes than intended, or is when it is not handled in accordance with the instruction manual, the full responsibility for any consequences will rest with the user. Any damages to the product or accessories are not covered by the warranty.

  • Correct placement and maintenance of the motor filter and the dust collector as described in this manual is necessary to avoid any damages to the appliance. Any damages caused by improper use or missing dust collector or filters are not covered by the warranty.

  • Always return the appliance after a malfunction, or if it has been damaged in any manner to the Customer Service Department for examination, repair or adjustment.

  • Never immerse any part of the main body, power cord and plug into water or any other liquid to protect yourself against electrical hazards.

  • Make sure that children do not touch the cord or appliance.

  • Keep the cord away from sharp edges and hot parts or other heat sources.

  • Always ensure that your hands are dry before handling the plug, switch or power cord.

  • Should you decide not to use the appliance anymore, make it inoperative by cutting the power cord after removing the plug from the socket. We also recommend making all potentially dangerous parts of the appliance harmless, particularly for children who might be tempted to play with them.

  • Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and electronic equipment marked with the symbol indicating separate collection of such equipment must be returned to a municipal waste collection point.

product description

  1. On/ off button
  2. Dust collector
  3. Clip to empty the dust collector
  4. Compartment for the HEPA filter
  5. Button to release the dust collector
  6. Button to disconnect the tube
  7. Tube
  8. Button to disconnect the turbo brush
  9. Turbo brush wit LED lighting
  10. Wall mounted hook
  11. Upholstery nozzle
  12. Combination crevice nozzle
  13. Adaptor
  14. Inlet for adaptor

Before first use

Follow these instructions when using the vacuum cleaner for the first time: Carefully remove the vacuum cleaner from the packaging and remove all traces of packaging from the device and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach of children. After unpacking the vacuum cleaner, check the device for external damage that may have occurred during transport. Place the vacuum cleaner on a secure, dry and level surface.
It takes 5 hours or so to fully charge the battery before the first use.

Assembly

The following parts can be found in the giftbox:

  • Turbo brush
  • Tube
  • Hand vacuum cleaner
  •  Wall mounted hook
  • Battery
  • Adaptor
  • Combination crevice nozzle
  • Upholstery nozzle

INVENTUM-STS725RC-Stick-Vacuum-Cleaner-06

INSTALLING THE BATTERY

Install the battery in the body of the vacuum cleaner according to the picture. Make sure it locks in properly.

CONNECTING AND DISCONNECTING THE TURBO BRUSH

  • Align the connection of the turbo brush with the connection of the tube and connect the two parts.
  • Press the button [8] to disconnect the turbo brush.

CONNECTING AND DISCONNECTING THE TUBE

  • Align the connection of the hand vacuum cleaner with the connection of the tube and connect the two parts.
  • Press the button [6] to disconnect the hand vacuum cleaner.
MOUNTING THE WALL MOUNTED HOOK

Install the wall mounted hook with the enclosed screws and plugs to the wall near a socket for the adaptor.

  • Place the wall mounted hook [10] with the rounded end upwards against the wall.
  • Mark wit a pencil the two holes on the wall.
  • Drill two holes of Ø 8 mm on the markings of at least 4 cm deep.
  • Push in the plugs.
  • Fix the wall mounted hook on the wall with the screws.

CHARGING THE VACUUM CLEANER
Hang the vacuum cleaner with the bottom of the handle on to the wall mounted hook. Plug the connector of the adaptor in the inlet at the back of the handle [14].
Plug in the adaptor. As soon as the adapter is plugged in the vacuum cleaner will charge.
The indicator light turns blue one bar at a time.
When the battery of the vacuum cleaner is empty, the charging will take 5 hours.
When the battery is completely charged, the four bars will light up continuously.
Always unplug the adaptor when the battery is fully charged. The adaptor may become warm during charging – this is normal.

TIPS

  • A fully charged battery will give continuous cleaning of approx. 25 minutes.
  • The battery has a build in self-protection safety. When the surface temperature of the battery exceeds 50°C or gets below 0°C, the battery will stop charging. The charging will continue when the surface temperature of the battery is between 0°C and 45°C.
  • During use the surface of the battery can not exceed 65°C. The battery will enter the self-protection mode and the battery will cut off the electricity to the vacuum cleaner. When the surface temperature of the battery goes back below 65°C, the vacuum cleaner can be used again.
  • We recommend that you discharge the battery at least once a month and then fully recharge it, to maintain optimal performance.

Warning! Always ensure your hands are dry before placing the appliance on the charging stand.
Warning! Never touch the brush inside the turbo brush when the appliance is on.
Warning! Only use the original included adaptor to charge the vacuum cleaner. Other adaptors can damage the appliance and even be dangerous.

Using the vacuum cleaner

SWITCHING THE VACUUM CLEANER ON

Press the on/off button [ 1 ] on the handle of the vacuum cleaner to switch the vacuum cleaner on. Press the on/off button [ 1 ] on the handle button again and the vacuum cleaner will shut off.
The turbo brush will rotate automatically when the vacuum cleaner is switched on. The LED lights on the turbo brush only work in dark areas. If the working area is bright adequately, the lights don’t work. When you move the turbo brush into dark area, the lights will light up.

USING THE VACUUM CLEANER AS A HAND HELD

  • The vacuum cleaner can also be used as a hand vacuum cleaner.
  • Disassemble the turbo brush and the tube.
  • The hand vacuum cleaner can be used with or without the turbo brush or with the combination crevice nozzle.
  • Press the on/off button [ 1 ] on the handle of the hand vacuum cleaner to switch it on. By pressing it again, you will shut the vacuum cleaner off.

The crevice nozzle can be used in two ways: with or without the brush. The upholstery nozzle can be placed onto the crevice nozzle.

INDICATION OF THE INDICATION LIGHT
The vacuum cleaner has indication lights which announce the battery with four bars.

  • 1 bar _ flashing: battery is 1 to 8% full.
  • 1 bar _ continuously: battery is 8 to 25% full
  • 2 bars __ : battery is 25 to 50% full
  • 3 bars ___ : battery is 50 to 75% full
  • 4 bars____ : battery is 75 to 100% full.
STORAGE

Hang the vacuum cleaner after every use on the wall mounted hook.
When the vacuum cleaner needs to charged, make sure the adaptor is plugged in and the adaptor is connected to the vacuum cleaner. Always unplug the adaptor when the battery is fully charged.

Maintenance

Check the dust collector and filters regularly to prevent any problems. Empty the dust collector when it is full and clean or replace the filters when they are dirty.

EMPTYING THE DUST COLLECTOR
Empty the dust collector after every use. First remove all accessories before emptying the dust collector.

INVENTUM-STS725RC-Stick-Vacuum-Cleaner-12

  • Hold the dust collector above a dust bin and unlock the lid with the clip.
  • To fully empty the dust collector, calmly shake it above the dust bin and close the lid.

CLEANING THE CYCLONE SYSTEM AND THE FILTERS
First remove all accessories before cleaning the vacuum cleaner. Clean the filters and the cyclone system once every four times you have emptied the dust collector.

  • Press the button to release the dust collector and remove it by turning it clockwise.
  • Remove the cyclone system by turning it clockwise.
  • The separate parts can be cleaned under lukewarm water.
  • Press the release button on top of the vacuum cleaner to remove the lid of the HEPA filter compartment.
  • Take out the HEPA filter and clean it under lukewarm water and let it air dry. Do not use any cleaning agents or brushes. Cleaning the filter will remove the dirt, but will not restore the original color of the filter. The color of the filter is not of any influence to the performance.
  • Re-assemble the vacuum cleaner in reverse order when all the parts are thoroughly dry. You will hear a click when the dust collector is placed correctly.

Attention

  • Use the vacuum cleaner only when the filters are in place. If not, it can lead to loss of suction power or damage to the motor.
  • Torn filters or filters that do not fit properly can cause damage to the engine. Replace a damaged filter by an original new one.

CLEANING THE TURBO BRUSH
Hair and /or other dirt can be stuck in the brush of the turbo brush. Therefore clean the turbo brush regularly to ensure efficiency of the vacuum cleaner.

  • Make sure the vacuum cleaner is switched off and and disconnect the turbo brush.
  • Unlock the tab at the bottom of the turbo brush with a coin or flat screwdriver and flip it upwards.
  • Carefully pull out the brush.
  • Clean the brush under lukewarm water and let the brush air dry.
  • Place the brush back in the turbo brush.
  • Close the tab and lock it with a coin or flat screwdriver.

frequently asked questions

Problem Possible cause Solution
The vacuum cleaner does not switch on. The battery is empty. Charge the

battery. The indication light is red while charging.
The battery does not charge (indication light does not light up when charging).| Replace the connector into the vacuum cleaner.
The temperature of the battery is too high.| Leave the vacuum cleaner to cool down for 30 minutes at room temperature and then turn it back on.
The adaptor is defect.| Contact the customer service of Inventum.
The suction power is decreased.| The dust collector is full.| Empty the dust collector.
The filters are clogged.| Clean the filters or replace them when they are worn or damaged.
The vacuum cleaner makes more noise.| The dust collector is full.| Empty the dust collector.
The filters are clogged.| Clean the filters or replace them when they are worn or damaged.
The brush of the turbo brush no longer rotates.| Dirt or hair block the brush| Clean the turbo brush according to the instructions.
The battery does not charge.| The vacuum cleaner is not connected correctly to the adaptor.| Replace the connector into the vacuum cleaner and check weather the adaptor is plugged in.
The temperature of the battery is too high (> 55°C) or too low (< 0°C).| Leave the vacuum cleaner to cool down for 30 minutes at room temperature and then turn it back on.

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals