DANCOVER AC06018 Parasol Light User Manual

: June 8, 2024
: DANCOVER

Table of Contents

DANCOVER AC06018 Parasol Light User Manual
How to use led umbrella light
Contact information
- References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DANCOVER AC06018 Parasol Light User Manual

DANCOVER AC06018 Parasol Light.jpg

How to use led umbrella light

Carefully take the product from the package. Insert batteries to the battery case, Batteries not included.
Carefully unclip the two sections of the light and place around your umbrella pole at the desired height. The inner clamps should hold against the umbrella pole, clip the two sections securely together. See below diagram#1, the item should be fitted onto your umbrella pole.
The lighting can be activated via the on/off switch button at the side of the unit.

After using the light continually, it may begin to fade. When this happens, it is time to change the batteries inside the umbrella light.

WARNING

Do not mix alkaline, standard (Carbon-Zinc) or rechargeable (Nickel-Cadmium) batteries.
Do not mix old and new batteries.
Exhausted batteries should be removed from the case and dispose the batteries safely.
The supply terminals are not to be short-circuited.
Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity.

How to replace batteries

A. Led umbrella light unit
This product is battery operated and powered by 3 X 1.5V AA Battery (battery not included).
Battery Type: “AA” size batteries required
Rating: 1.5V
Quantity: 3 pcs

Make sure the switch button is at “Off” position.
Sliding open the battery case cover, remove the exhausted batteries and dispose properly.
Insert 3pcs new “AA” batteries matching the polarity shown in the battery case. See diagram#2.
Sliding close the battery case cover.

The wheelie bin symbol indicates the product and batteries must not be disposed of in the domestic waste as they can contain substances that are damaging to the environment. Please use designated collection points or recycling facilities when disposing of the item or batteries.
Batteries should be removed from the product.
Please property dispose batteries.

FIG 2 How to replace batteries.JPG

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.