CADAC 8515-FL-QR Campingaz Overflow Regulator Quick Release Instructions

June 5, 2024
CADAC

CADAC 8515-FL-QR Campingaz Overflow Regulator Quick Release Instructions
CADAC 8515-FL-QR Campingaz Overflow Regulator Quick
Release

NOTE! PRODUCT MAY VARY FROM ILLUSTRATIONS

Single-Stage, Low Pressure
LP Gas Regulator Type A500i 2531CT-0019
OPERATING INSTRUCTIONS TO BE KEPT BY THE USER
Read carefully before use

Safety Information

  • Always install the regulator in Gas OFF position only.
  • In normal conditions of use, in order to ensure a safe operation of installation. It is recommended that the regulator should be changed every 10 years from the date of manufacture.
  • For outdoor use, the device should be positioned and protected against direct contact of water.
  • Before installation make sure that the rubber gasket in the cylinder valve or regulator is in good condition.
  • Make sure all valves on the appliance are turned off.
  • Use LPG cylinders in an upright vertical position only.
  • For rubber hoses should not be more than 5-10 years old.
  • Do not try to remove the regulator while the gas is ON.
  • Do not move the LPG cylinder while in operation.
  • Do not change the LPG cylinder in the presence of candle lights or any naked flames.
  • When the regulator is installed downstream of another regulator, the supply pressure range shall be correct for the regulated pressure range of the upstream regulator, plus any pressure losses in the interconnecting pipe work.
  • That downstream installation pressure loss shall not exceed the ΔP marked on the device.
  • If fitting the regulator indirectly to a pressurized tank:
    The regulator must not be positioned lower than top of the tank or outlet valve.
    This is to avoid any gas vapor which may have re-liquefied from draining down into the regulator.
    Any additional pipes or hoses used to connect the regulator must be inclined so that any liquefied or condensed gas can drain back into tank.

Installation

  • Check the gasket/seal on the cylinder valve is in place and in good condition.

  • If the gas valve is not in good condition, ask your gas dealers to replace it with another cylinder valve.
    Start the installation:

  • Conduct a visual inspection of the regulator. Remove any dirt or loose metal shavings.

  • Fit the gas hose to the regulator outlet nozzle. Use water or liquid soap for lubrication of the hose. Insert firmly and clamp it using the hose clamp. If the regulator has a threaded outlet, tighten the nut on the hose to the regulator by hand, then tighten the nut firmly by use of a wrench.
    Attach the hose to the gas appliance in a similar way.

  • In total absence of any flame, remove the protection seal or cap from the gas cylinder valve.

  • Tighten the regulator hand wheel firmly by hand. No tools needed.

  • Open the knob on regulator counter clockwise, minimum of one full turn.

  • Press the excess flow valve push button on the outlet of the regulator to fill gas into the hose, wait 5 seconds.

  • Perform a leak test by use of the manometer gauge. If no leaks, the gas appliance can be started up.

  • If any leaks, check installation and restart leak test procedure.

  • To replace the cylinder turn the gas cylinder valve OFF. Unscrew the regulator.

Gas Level Indicator

Current gas level should be read when the gas appliance is in use, following these color indicators:

Blue : The cylinder is nearly empty, no more liquid gas in the cylinder.
Yellow : The cylinder will soon be empty, plan to refill soon.
Green: Enough gas for continuous gas consumption.

Leak Test Procedure

  • The regulator is connected to the gas appliance with the gas hose. Gas appliance valves shall be in closed/off position.
  • The regulator is attached to the gas cylinder valve.
  • Open the gas flow by turning the gas cylinder valve control knob open.
  • After filling up the regulator and hose with gas, close the regulator valve again. The gas is now trapped between the gas regulator and gas appliance.
  • The manometer dial goes into the Green area of the scale.
  • Wait 2-5 minutes. If the dial is still in the green area of the scale without moving, the installation is free of any leakage.
  • In case the dial is moving into the yellow or blue area the installation has a leak.
  • Go through the installation with leak spray or water soap solution to identify the leak.
  • Gas appliance should not be used until all leaks have been eliminated.

Technical Data

Technical Data

| 28-30mbar| I 50mbar| | 28-30mbar| 50mbar
Model No.:| A500i| AP5(mbar):| | 5
Gas Type:| Butane| Working temperature:| 0-50 deg Celcius
Inlet Pressure (bar):| 0.3 – 7.5| Capacity:| 1.5kg/h| I 1.0kg/h
Nominal Outlet Pressure(mbar):| 28 – 30| 50| Inlet connection:| M14, M16, 7/16″
LP2(mbar):| 2| | Outlet connection:| All relevant to EN 16129

Customer Support

Integrated Gas Technologies LtD
Gydevang 39-41 – DK3450-Denmark
Email: sales@igt-lpg.com
Website: www.igt-lpg.com
Tel: +45 45769921
Fax: +45 45769821

CADAC INTERNATIONAL
P.O. Box 43196,
Industria, 2042 South Africa
Tel: +27 11 470 6600
Email: info@cadac.co.za
www.cadacinternational.com

CADAC EUROPE
Ratio 26, 6921 RW Duiven
The Netherlands
Tel: +31 26 319 7740
Email: info@cadaceurope.com
www.cadacinternational.com

CADAC GERMANY
Ratio 26, 6921 RW Duiven
The Netherlands
Tel: +31 26 319 7740
Email: info@cadaceurope.com
www.cadacinternational.com

CADAC UK
14 Deanfield Court,
Link59 Business Park,
Clitheroe, Lancashire,
BB7 1QS
United Kingdom.
Tel: +44 (0) 333 2000363
E:mail: info@cadacuk.com
www.cadacinternational.com

CADAC SCANDINAVIA
Millarco International A/S
Rokhøj 26
8520 Lystrup, Denmark
Phone: +45 87 43 42 00
millarco@millarco.dk
www.millarco.com

CADAC Czech Rep.
RÖSLER Praha spol. s r.o.
K Horkám 19/21
102 00 Praha 10 Česká republika
Tel: +420 267 188 011
Email: info@rosler.cz
www.rosler.cz

CADAC MOZAMBIQUE
Exclusive Brands Africa
492 Avenida Namaacha
Maputo, Mozambique
Tel: +258 21 406254
www.cadac.co.mz

CADAC MONTENEGRO
City kvart Z1L6
81000 Podgorica, Montenegro
Tel 38220671446,
38269020063
E-mail: coca@t-com.me

CADAC FINLAND
OY KAMA FRITID AB
Koivuhaantie 2-4 B
01510 VANTAA
00358 20 792 0310
info@kamafritid.fi

CADAC IRAN
Robin Bazarganan Carin Co.
Unit D, 6th Floor, Negin Zafar
Building, No.1327,
Shariati Street, Tehran, Iran
Tel: +98 21 276 00 781
Mail: info@cadac.ir

CADAC DENMARK
Camper Fritid
Industrivej 11
6640 Lunderskov, Denmark
Tel.: +45 7558 5255
Email: info@camper.dk
www.camper.dk

CADAC POLAND
Kamai
Wola Batorska 461
32-007 Wola Batorska Poland
Tel: +48 12 635 1373
Email: handlowy@kamai.pl
www.kamai.pl

CADAC CHINA
Room 807, Huayue International
Building, No.255 Tiangao Road,
South
Yinzhou business district,
Ningbo, China
Tel:+86 574 87723937
Email: info@cadac.com.cn

CADAC ZIMBABWE
Exclusive Brands Africa
Unit 8 Birkenhead Park
43 Josiah Chinamano Street
Belmont, Bulawayo
Tel: +263 971 740 (Bul)
Tel: +263 479 2564 (Har)
www.cadac.co.zw

CADAC ZAMBIA
Exclusive Brands Africa Limited
7225A Kachidza Road
Light Industrial Area
Lusaka, Zambia
Tel: +260 211 842015
Tel: +260977 345034
Email: info@ebagrp.com

CADAC SWEDEN & NORWAY
KAMA FRITID AB
0046 36 353700
info@kamafritid.se

CADAC logo

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals