CADAC 343, 343-QR Threaded Cartridge Regulator Installation Guide
- October 30, 2023
- CADAC
Table of Contents
CADAC 343, 343-QR Threaded Cartridge Regulator
CAUTION
Provide ample ventilation. Do not use this appliance in an unventilated space
to avoid endangering your life. If still more gas appliances and/or occupants
using gas are added to the space, additional ventilation must be provided.
IMPORTANT
Read these instructions carefully so as to familiarize yourself with the
appliance before fitting the appliance to a gas cylinder.
Retain these instructions for future reference.
General
- This regulator is used with Butane disposable threaded cartridges.
- A regulator is an appliance that converts the high pressure inside a cartridge to low pressure after it exits the regulator. The outlet pressure is set at a fixed pressure of 29mbar and this is independent of the inlet pressure of the gas cartridge. The gas cartridge internal pressure varies significantly depending on the temperature of the cartridge. Therefore use of a regulator ensures that the appliance works at a constant pressure and not a variable one.
- Make sure that the horizontal outlet valve on the regulator is in the “off” position. Connect the cartridge to the regulator by screwing the cartridge into the underside of the regulator.
- Ensure that both the regulator and the rubber seal on the regulator are in good condition and that the seal is not worn, damaged or perished.
- Connect the outlet hose connector to the appliance and ensure that it is tightened properly. This requires a small twist using a spanner as it must not just be “finger-tight”.
- Open the regulator outlet valve fully. Use soapy-water to check for leaks at all connections. A leak will be visible by bubbles appearing in the soapy water. If a leak is found, turn off the cartridge valve and ensure all connections are tight. If the gas leak persists, remove the cartridge from the regulator and return the leaking part to the original store of purchase. The leak may be between the cartridge and the regulator, on the hose, or between the hose and the appliance.
- Under normal conditions of use, in order to ensure the correct operation of the installation, it is recommended that this regulator is changed within 10 year of the date of manufacture.
- The regulator is for outdoor use only! Keep it away from any source of flammable materials.
- Do not move the cartridge during operation.
- Only to be used with EN417 type disposable cartridges
Assembly & Use
343
-
Hand wheel (17mm Hex) and hose component
-
Move the handle wheel to the end of the hose sliding it over the brass nut.
-
Connect brass nut to the inlet of the BBQ, turn the hand wheel to tighten.
343-QR
-
Remove QR male.
-
Connect QR male to the inlet of your product and turn to tighten.
-
Connect QR female to QR male by pushing the QR female onto the QR male.
Customer Service
CADAC INTERNATIONAL
P.O. Box 43196,
Industria, 2042 South Africa
Tel: +27 11 470 6600
Email: info@cadac.co.za
www.cadacinternational.com
CADAC UK
14 Deanfield Court,
Link59 Business Park,
Clitheroe, Lancashire, BB7 1QS
United Kingdom.
Tel: +44 (0) 333 2000363
E:mail: info@cadacuk.com
www.cadacinternational.com
CADAC DENMARK
Camper Fritid
Industrivej 11
6640 Lunderskov, Denmark
Tel.: +45 7558 5255
Email: info@camper.dk
www.camper.dk
References
- דף הבית - מאפיית ברמן
- Premium Outdoor Furniture in HK | Everything Under The Sun
- CADAC Dometic Barbecues | Official Website
- CAMPER.DK - Alt i campingudstyr, reservedele og tilbehør til camping
- Kamai.pl - partner w sprzedaży B2B
- Millarco
- Rösler Prague - Consultancy for your projects