FALCON RIDGE CF Moto ZForce 950 Sport Rear Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE CF Moto ZForce 950 Sport Rear Windshield
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the product before removing protective film. Once the film is removed you cannot return the product for a full refund.
INSTALLATION INSTRUCTION
- Be sure to read these instructions thoroughly before opening and installing the Wildcat Trail / Sport Polycarbonate Rear Window.
- Check over the parts included in the cartons with the parts list shown below:
- 1 ¾” Loom Clamps: 6 each
- 1” Bolts: 6 each
- Thumb Nuts: 6 each
- Small Washers: 6 each
- End Bulb Gasket: 35” piece
- Rear Window: 1 each
- Start by pulling it out of the box, find a clean area to lay it down, and install the hardware. Peel off the protective film from both sides of the Rear Window. Next install the rubber gasket along the bottom of the window.
- Take the six Loom clamps and place them around the roll cage at each of the slots on the sides and across the top as shown in the photo below.
- Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using micro fiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>