Dongguan Y22 Wireless Mouse User Manual
- June 5, 2024
- Dongguan
Table of Contents
Dongguan Y22 Wireless Mouse
Getting Started
- Tum on your computer
- Hold the mouse top cover release button while sliding the top cover backward and lifting it up
- Take the USB receiver out of the mouse (middle of battery compartment) and plug the USB receiver into a USB port on your computer
- Install two AAA batteries (not included) in the battery compartment
- Reattach the top cover by pushing it down at the back and sliding it forward
- Tum on the mouse with the on/off switch on the bottom
- Wait for a few seconds until your computer recognizes the mouse before use
- Press the DPI adjustment button to switch between the 3 DPI levels
- If the batteries are rechargeable, you can use a USB-C cable not included) to recharge them.
E-Key Actions
- Single-click to go back to the computer desktop
- Double-click to lock the computer
- Long-press to put the computer in sleep mode
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>